Table of Contents
Advertisement
en Installation instructions
2.5 Positioning the appliance
Note: Do not remove the adhesive seal fitted on the
lower edge of the cooktop. The adhesive seal prevents
the penetration of liquids.
Do not use silicone to bond the appliance to the work-
top.
Position the cooktop with the upper side facing
1.
down on a flat, stable surface.
Loosen the screws on the brackets so they can turn
2.
freely. You do not need to fully undo the screws on
the brackets.
Turn the cooktop around and insert it into the re-
3.
cess. Insert the cooktop in the front of the recess.
Turn the brackets and tighten them fully.
4.
The position of the brackets depends on the work-
top thickness.
2.6 Electrical connection
Follow the instructions for electrical connection.
¡ An electrical 10 amp socket needs to be within 1 m
of the hotplate to allow electrical connection. The
socket must remain accessible after installation of
the appliance.
8
¡ This appliance is connected to the mains (240 VAC)
by means of the connecting lead. The connecting
lead must be fixed to the kitchen unit to prevent it
from coming into contact with hot parts of the cook-
top or an oven installed underneath and remain ac-
cessible after installation of the cooktop.
¡ This appliance must be earthed. When connecting
the cooktop ensure that the earth wire is connected
first and that all wires are connected to the correct
terminals.
Wiring diagram
Observe the wiring diagram.
a
Switch
b
Blue wire
c
Brown wire
d
Terminal
e
Ignition module
2.7 Gas connection
Only an officially authorised technician should connect
the appliance.
Before connecting the gas
Observe any special conditions imposed by local sup-
pliers (utilities).
¡ During the planning stage, consider the position of
supply connections.
¡ The cooktop must be connected to the gas supply
with upstream connection of an isolation valve in ac-
cordance with the respectively valid regulations. We
recommend that the isolation valve be fitted prior to
the cooktop to enable isolation of cooktop from gas
supply. The valve must be easily accessible at all
times.
Advertisement
Table of Contents
