Siemens FS720 Mounting & Installation page 140
Fire detection system
Hide thumbs
Also See for FS720:
- Configuration (412 pages) ,
- Mounting & installation (222 pages) ,
- Commissioning, maintenance, troubleshooting (178 pages)
Table of Contents
Advertisement
Installing, exchanging and connecting modules
7
Ethernet switch FN2008 and safety module FN2009
140 | 248
Building Technologies
Fire Safety
View and installation of mounting kit FHA2029
5
4
3
2
Figure 73: Mounting kit FHA2029-A1 for installation on the DIN rail
1
2 fixing screws for the bottom DIN rail
2
Bottom DIN rail
3
Angle plate for the Ethernet switch
4
Retaining bracket for lateral fixing
5
Upper DIN rail
6
2 fixing screws for the top DIN rail
The mounting kit FHA2029 can be installed on both sides of the housing
(installation on left or right side wall). The angle plate must be rotated 180 degrees
to fit it on the right-hand side wall.
The process for installing stations and empty housings is identical. In stations there
must be sufficient space for the modules.
1. Firstly use the screws (6) to install the DIN rails (2, 5) and the retaining bracket
(4) on the angle plate.
2. Fit the angle plate (3) on the left-hand side of the housing as shown (or rotated
180 degrees for the right-hand side of the housing) and screw it firmly in place.
In the Eco and Standard housings, ensure that the two lugs go into the
recesses for the power supply (70 W).
3. Fit the modules as described below.
4. Wire the modules as described below.
A6V10210390_m_en_--
2018-08-29
Advertisement
Table of Contents
