HP 1810-48G Quick Setup Manual

Hide thumbs Also See for 1810-48G:

Download this manual

HP 1810-48G Switch Quick Setup Guide

The switch drawings in this document are for illustration only and may not match your particular switch model.

For more detailed instructions and information to set up your switch, view or download the Installation and Getting Started

Guide for your switch at www.hp.com/networking/support.

Unpack and check included parts.

Prepare for installation. To avoid personal injury or product damage, review the "Safety Precautions" on

page 4.

. Power on and verify that Self-Test completes normally. The switch does not contain a power switch. It is turned on

by connecting power through the AC power cord.

Install the Switch Hardware. Turn off the switch before installing the switch hardware.

Rack Mounting: Use a #1 Phillips (cross-head) screwdriver to attach the accessory kit brackets to the switch using the

eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the rack.

Table or Desktop: Attach the four self-adhesive pads

(included in the accessory kit) to the bottom corners of

the switch.

Documentation kit

■

Switch

■

Accessory kit (installation hardware)

■

AC power cord

■

After Self-Test:

Power LED = On

Fault LED = Off

Page 1 HP 1810-48G Switch Quick Setup Guide The switch drawings in this document are for illustration only and may not match your particular switch model. For more detailed instructions and information to set up your switch, view or download the Installation and Getting Started Guide for your switch at www.hp.com/networking/support.
Page 2 192.168.2.10 Subnet mask 255.255.255.0 Default gateway not set See the example on page 3. . Connect Network Cables. Note: For transceiver connections, install and use only HP mini-GBIC/SFP transceivers supported by the switch. See “Mini-GBIC/SFP Installation Notes” on page 3.
Page 3 — you may not get a link. For some older network devices, including some older HP devices, the default speed/duplex settings may be predefined (for example, to 1000 Mbps/Full Duplex), or otherwise set differently from the default configuration of your switch port.
Page 4: Safety Precautions
Ensure the air flow around the switch is not restricted. Leave at least 7.6 cm (3 inches) for cooling. For the air flow ■ direction, see the Installation and Getting Started Guide for your product, located on the HP ProCurve Web site at www.hp.com/networking/support.