Table of Contents
Advertisement
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
wireless
card.
4. Remove the
display
assembly.
5. Remove the
display hinge
6. Remove the
display
bezel.
7. Remove the
display
hinges.
8. Remove the
display
panel.
9. Remove the camera.
10. Remove the
display
cable.
About this task
NOTE:
This procedure applies only to computers with a plastic chassis.
NOTE:
The display back-cover and antenna assembly cannot be further disassembled once all the pre-removal parts
procedures are completed. If the wireless antennas are malfunctioning and are required to be replaced, replace the entire
display back-cover and antenna assembly.
The image below shows the display back-cover and antenna assembly after the pre-removal parts procedures have been
performed for any display back-cover and antenna assembly replacement.
Steps
After performing the pre-requisites, you are left with the display back-cover and antenna assembly.
Installing the display back-cover and antenna assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Before working inside your
caps.
computer.
Removing and installing Field Replaceable Units (FRUs)
105
Advertisement
Table of Contents
