Lubricating The Wheel Gears; Replacing The Blade - Toro 20384 Operator's Manual
Super recycler lawn mower
Hide thumbs
Also See for 20384:
- Operator's manual (28 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (24 pages)
Table of Contents
Advertisement
Figure 31
1. Cover
2. Fuse holder
3. Spare fuse
Note:
Your machine comes with a spare fuse in
the battery compartment.
4.
Install the cover over the battery compartment
(Figure
31).
Lubricating the Wheel
Gears
Service Interval: Every 25 hours
1.
Wipe the grease fittings just inside the rear
wheels with a clean rag
Figure 32
1. Grease fitting
2.
Install a grease gun onto each fitting and gently
apply 2 or 3 pumps of No. 2 lithium grease.
g189463
4. Battery compartment
5. Fuse
(Figure
32).
g003234
Replacing the Blade
Service Interval: Yearly
Important:
You will need a torque wrench to
install the blade properly. If you do not have a
torque wrench or are uncomfortable performing
this procedure, contact an Authorized Service
Dealer.
Examine the blade whenever you run out of fuel. If the
blade is damaged or cracked, replace it immediately.
If the blade edge is dull or nicked, have it sharpened
and balanced, or replace it.
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
1.
Refer to
Preparing for Maintenance (page
2.
Tip the machine onto its side with the air filter up.
3.
Use a block of wood to hold the blade steady
(Figure
33).
4.
Remove the blade, saving all mounting hardware
(Figure
33).
5.
Install the new blade and all mounting hardware
(Figure
34).
26
Figure 33
23).
g231389
Hide quick links:
Advertisement
Table of Contents
