Table of Contents
Advertisement
Prepare for Installation
• Take care when connecting units to the supply circuit so that wiring is not overloaded.
• This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
• To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the
• Hazardous voltage or energy is present on the backplane when the system is operating. Use caution
• When installing or replacing the unit, the ground connection must always be made first and disconnected
• The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor before you slide
• Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams
Review Installation Guidelines
Before installing the chassis, verify that these guidelines are met:
• Site is properly prepared so that there is sufficient room for installation and maintenance. For specifications
• Operating environment is within the ranges listed in
• Chassis is mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting the chassis in a partially filled rack, load the rack from the bottom to the top with the
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
• Airflow around the chassis and through the vents is unrestricted.
• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting
• For cable requirements for SFP+ module connections, see the
Procure Tools and Equipment
Obtain these necessary tools and equipment for installing the chassis:
• Number 1 and number 2 Phillips screwdrivers with torque capability to rack-mount the chassis.
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available.
handles on modules (such as power supplies, fans, or cards); these types of handles are not designed to
support the weight of the unit.
when servicing.
last.
the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over.
or view directly with optical instruments.
on the clearances required for chassis installation, see
page 61
heaviest component at the bottom of the rack.
chassis in the rack.
fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.
on page 68
section. Each port must match the wave-length specifications on the other end of the cable,
and the cable must not exceed the maximum cable length.
Clearance Requirements, on page
Environmental and Physical Specifications, on
Hardware Installation Guide for Cisco NCS 5500 Series Fixed-Port Routers
Review Installation Guidelines
64.
Transceivers, Connectors, and Cables,
5
Advertisement
Chapters
Table of Contents
