Table of Contents
Advertisement
4
Functions
Additional functions
Note
Set Away (Holiday
mode)
Note
4.6.6 Humidity (RDG2..KN)
Humidity control (P007,
P450)
Room humidity
60 | 186
Set DATE
The scheduler function must be enabled before setting the date:
●
Press
once and then turn the rotary knob or press
programming mode DATE.
●
Press
once to enter the date setting.
●
Turn the rotary knob to select month / weekday / year, then press
●
For example, enter the year setting. The Year value flashes and can be
changed by turning the rotary knob.
●
Press
once to confirm the adjusted value, or
Repeat steps for month and weekday settings.
Power reserve clock for 20 h during power failure (RDG2..T)
Set AWAY (Holiday mode)
The holiday start time (date and month) can be set after entering holiday mode.
The scheduler function must be enabled before setting the holiday period:
●
Press
once and then turn the rotary knob or press
programming mode AWAY. Holiday mode
arrives.
●
Press
once to enter scheduler mode
●
Turn the rotary knob to adjust the number of days (holidays), then press
once.
●
Set the start time (AWAY): Set the month (MON) and then press
day (DAY)
●
Press
once to confirm the adjusted value; the idle page for Holiday mode is
displayed.
●
Holiday mode only can be set via local HMI.
●
Only the local HMI or window contact/presence detector can stop holiday
mode. Intervention from the bus cannot change the mode. Holiday mode
remains active until the next intervention from a local HMI or window
contact/presence detector is received.
●
The set holiday mode is deleted once the holiday period ends; user must set a
new one for the next year as needed.
Humidity control limits humidity in the room according to the selected setpoint
(low/high) by shifting the temperature setpoint, or by enabling outputs to release
the external equipment as needed, e.g., the dehumidifier or humidifier.
Humidity control is active in Comfort and Economy mode when P450 is set to 1.
The function can be disabled by setting P450 to 0 (factory setting).
Humidity function is disabled in Protection mode.
The humidity level in the room is acquired by the built-in sensor. The thermostat
can receive the relative humidity via the bus if a valid humidity value is available
and selected on KNX (S-Mode or LTE-Mode).
The priorities are set as follows:
1. S-Mode
–
By setting parameter "Room relative humidity" in the ETS to Receive, the
thermostat can display the relative humidity measured by an external
sensor on the bus.
continuously to select
(Esc) to cancel the change.
continuously to select
is displayed once the start time
.
A6V11545892_en--_e
once.
⇒ Set the
Advertisement
Table of Contents
