Advertisement
Quick Links
Advertisement
Related Manuals for TASKING ADIO
Summary of Contents for TASKING ADIO
- Page 1 ADIO ADD-ON MODULE HARDWARE USER MANUAL V1.6, March 2024 www.tasking.com...
- Page 2 Use included power cord and power supply The enclosed power supply has been approved for use by TASKING. Please contact TASKING if you need to consider an alternative power.
-
Page 3: Table Of Contents
Contents Package content ....................4 Specifications ....................5 Device description .................... 6 SPI Protocol Analyzer ..................8 Hardware Configuration and Setup ..............9 Accessories ....................10 www.tasking.com... -
Page 4: Package Content
Package content The ADIO kit is delivered with the following components: 1m FNet ADIO Grounding wire Micro Cable Ordering code: Ordering code: Ordering code: IC57041 BB-FNET-100 BB-WIRE 2x Sets of 5 clip set wires 5 pieces test clips set 1 m BNC cable 50 ohm... -
Page 5: Specifications
Two analog inputs, input impedance 530kOhm / 8pF, 12-bit resolution, AIN0, AIN1 input range ±5V, max. sampling rate 12 MHz 10-pin IDC connector Power Sense Provision for target power consumption measurement via the optional Power Probe (Ordering code IC50012). www.tasking.com... -
Page 6: Device Description
All CAN and LIN signals are isolated from the GND. The rear face features the remaining connector: E – FNet Port Although it looks similar to the HDMI interface, the FNet Port is not compatible with HDMI or any HDMI accessories. www.tasking.com... - Page 7 Connecting TASKING hardware to the HDMI devices will damage the hardware and will render the TASKING hardware warranty void. www.tasking.com...
-
Page 8: Spi Protocol Analyzer
2. Click Network and give it a meaningful name which is shown in the Analyzer window. 3. Add SPI description files (*.spi). Find TASKING SPI protocol description format in winIDEA Help. 4. Chip Select is required. Click Edit and select CS0, CS1 or CS2. -
Page 9: Hardware Configuration And Setup
1. Make sure that the iC7max/iC5700 is powered OFF. See the iC7max or iC5700 Hardware User Manual for detailed instructions how to connect the BlueBox to the Target. 2. Connect the ADIO FNet port with the iC7max/iC5700 FNet port using the supplied certified FNet cable (marked blue on the picture below). -
Page 10: Accessories
Accessories Ensure proper operation of your ADIO and iC7max/iC5700 by using approved TASKING power supplies and cables. Description Ordering Code Set of 5 clip set wires BB-CLIPWIRES5 5 pieces Test Clips set BB-CLIPSET5 1 m BNC cable 50 ohm BB-BNC50-100... - Page 11 Visit our website for: · Support - isystem.com/support · Tutorials - isystem.com/start · Knowledge Base - kb.isystem.com www.tasking.com www.tasking.com...