Table of Contents
Advertisement
58
Removing and installing memory
modules
The four 168-pin sockets on board support SDRAM-type DIMMs. You
may install 64-MB, 128-MB, 256-MB, 512-MB, or 1024-MB (single
density) DIMMs for a maximum of 4-GB system memory.
The SDRAM DIMMs should work under 3.3 volts only; 5-volt memory
devices are not supported. This mainboard supports both 100 and 133
MHz SDRAM. However, they cannot be used at the same time in the
system.
WARNING! Do not use both 100 MHz and 133 MHz SDRAM
together. Such a combination might cause your system to
malfunction. For a list of qualified DIMM vendors, please
contact your reseller.
Each of the DIMM sockets is independent from the others. This
independence allows you to install DIMMs with different capacities to
form different configurations.
Removing a DIMM
Before you can install a new DIMM in a socket, remove first any
previously installed DIMM from that socket.
1
Open the front panel and remove the side panel of the housing.
See page 38 for more information on opening the housing panels.
2
Locate the DIMM socket on the system board.
3
Press the holding clips on both sides of the socket outward to
release the DIMM (a).
Download from Www.Somanuals.com. All Manuals Search And Download.
3 Upgrading your system
Advertisement
Table of Contents
