Cisco UCS C Series Installing Manual page 3

Hide thumbs Also See for UCS C Series:

Table of Contents

Installing the Server

• Ensure that there is adequate space around the server to allow for accessing the server and for adequate

• Ensure that the air-conditioning meets the thermal requirements listed in the

• Ensure that the cabinet or rack meets the requirements listed in the

• Ensure that the site power meets the power requirements listed in the

Rack Requirements

The rack must be of the following type:

• A standard 19-in. (48.3-cm) wide, four-post EIA rack, with mounting posts that conform to English

• The rack-post holes can be square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), #12-24 UNC, or #10-32

• The minimum vertical rack space per server must be two rack units (RUs), equal to 3.5 in. (88.9 mm).

Supported Cisco Slide Rail Kits

The server supports the following rail kit options:

• Cisco part UCSC-RAIL-D (Ball bearing rail kit for C220 & C240 M7 rack servers)

• Cisco part UCSC-CMA-C220-D (Reversible CMA for ball bearing rail kit)

Rack Installation Tools Required

The slide rails sold by Cisco Systems for this server do not require tools for installation.

Slide Rail and Cable Management Arm Dimensions

The slide rails for this server have an adjustment range of 24 to 36 inches (610 to 914 mm).

The optional cable management arm (CMA) adds additional length requirements:

• The additional distance from the rear of the server to the rear of the CMA is 5.4 inches (137.4 mm).

• The total length of the server including the CMA is 35.2 inches (894 mm).

airflow. The airflow in this server is from front to back.

you can use an uninterruptible power supply (UPS) to protect against power failures.

universal hole spacing, per section 1 of ANSI/EIA-310-D-1992.

UNC when you use the Cisco-supplied slide rails.

Rack Requirements

Environmental

Specifications.

Rack Requirements, on page

Power

Specifications. If available,

Installing the Server

Table of Contents

Ucsc-rail-d Ucsc-cma-c220-d