Welcome to AEG! Thank you for choosing our appliance. Get usage advice, brochures, trouble shooter, service and repair information: www.aeg.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. TECHNICAL DATA..................7 5.
Page 3
the use of the appliance in a safe way and understand the hazards involved. • Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. •...
• The ventilation opening in the base must not be covered by a carpet, mat, or any floor covering. • The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre.
Page 5
2.4 Use • Always use a correctly installed shockproof socket. • Make sure that the parameters on the WARNING! rating plate are compatible with the Risk of injury, electric shock, fire, burns electrical ratings of the mains power or damage to the appliance. supply.
repairers, and that not all spare parts are • Disconnect the appliance from the mains relevant for all models. electrical and water supplies. • Concerning the lamp(s) inside this product • Cut off the mains electrical cable close to and spare part lamps sold separately: the appliance and dispose of it.
The rating plate reports: A. QR code Mod. xxxxxxxxx B. Model name Prod.No. 910000000 00 000V ~ 00Hz 0000 W C. Product number 00000000 D. Electrical ratings B C D E. Serial number Scan the QR code with the built-in camera app to register the appliance and for more additional information.
Page 8
4. Remove the three transit bolts and pull out the plastic spacers. Accessories delivered with the appliance may vary depending on the model. 2. Put the packaging element on the floor behind the appliance and carefully put it down onto its rear side. Remove the polystyrene protection from the bottom.
Page 9
The sector in the window shows this fault CAUTION! A. If this occurs, close the water tap and contact the authorized service center for Make sure there is no damage to hoses information to replace the hose. and there are no leaks from the couplings.
Page 10
It is possible to connect the drain hose in different ways: min.600 mm max.1000 mm * Subject to change spare parts without notice. Make sure that the drain hose makes a loop To a stand pipe with vent hole - Insert the to prevent particles going into the appliance drain hose directly into a drain pipe or stand from the sink.
Read carefully the instructions supplied with the accessory. Only appropriate accessories approved by AEG ensure the safety standards of the appliance. If unapproved parts are used, any claims will be invalidated. 6.2 Fixing plate kit If you install the appliance on a plinth that is not an accessory supplied by AEG, secure the appliance in the fixing plates.
7. CONTROL PANEL 7.1 Special features programme duration in 30 seconds. The washing programme is tailored to the Your new washing machine meets all modern laundry load and the type of fabric without requirements for an effective treatment of consuming more time, energy and water laundry with low water, energy and detergent than necessary.
7.3 Display A. Door locked indicator. hours counter" section in the B. Delay start indicator. "Settings" paragraph for more details. C. The digital indicator can show: D. Time Save bars level indicator. E. Drum clean indicator. • Programme duration (e. g. F.
Page 14
8.4 Spin 8.5 Prewash When you set a programme, the appliance With this option you can add a prewash automatically sets the default spin speed phase to a washing programme. allowed. The relevant indicator illuminates. Additional spin options: • Use this option to add a pre-wash phase •...
The Time Save is available only with the Pause button, the appliance begins the programmes in the table. countdown and the door is locked. 8.9 Time Save With this option you can reduce the programme duration depending on the load size and the degree of soiling.
Page 16
Programme Reference Maximum Programme description Default tempera‐ spin speed load (Type of load and level of soiling) ture Spin speed Temperature range range Delicates 1200 rpm 2 kg Delicate fabrics such as acrylics, viscose and 30°C (1200- 800 rpm) mixed fabrics requiring gentler washing. Normal‐ 40°C - Cold ly and lightly soiled items.
Page 17
Programme Reference Maximum Programme description Default tempera‐ spin speed load (Type of load and level of soiling) ture Spin speed Temperature range range 60min Wash 1400 rpm 5 kg Cotton and fast-coloured synthetic items. Complete 30°C (1400- 800 rpm) washing programme that, in only 60 minutes, 60°C - 30°C washes the daily soiled laundry intensively and en‐...
• The programme is completed (sequence seconds after the switching on. After of sounds for about 1 minute). these 10 seconds, the key combination • The appliance has a malfunction activates and deactivates the acoustic (sequence of short sounds for about 5 signals).
12. DAILY USE WARNING! Refer to Safety chapters. 12.1 Activating the appliance 1. Connect the mains plug to the mains socket. 2. Open the water tap. 3. Press the On/Off button for a few seconds to activate the appliance. A short tune sounds. 12.2 Loading the laundry CAUTION! 1.
Page 21
Compartment for liquid additives (fabric conditioner, starch). Maximum level for quantity of liquid additives. Flap for powder or liquid detergent. Always follow the instructions that you find on the packaging of the detergent products, but we recommend that you do not exceed the maximum indicated level.
Page 22
Changing the delay start after the countdown has started If a selection is not possible an acoustic signal sounds. To change the delay start: 12.6 Starting a programme 1. Touch the Start/Pause button to pause the appliance. The related indicator flashes. Touch the Start/Pause button to start the 2.
Page 23
12.11 Opening the door - Adding garments The AutoSense System is not available with all programmes such as :Wool, Rinse, and programmes with short If the temperature and level of the water cycles. in the drum are too high and/or the drum is still rotating you should not open the 12.9 Interrupting a programme and door.
The option indicator Rinse Hold disappears. When you activate the appliance again, 3. When the programme is completed and the display shows the end of the previous the door locked indicator goes off, programme. Turn the programme dial to you can open the door. set a new cycle.
Page 25
13.3 Detergent type and quantity • A very small load can cause balance problems with the spin phase leading to The choice of detergent and use of correct excessive vibration. If this occurs: quantities not only affects your wash a. interrupt the programme and open the performance, but also helps to avoid waste door (refer to "Daily Use"...
• Normally soiled laundry may be washed before drying your laundry in a tumble without prewash in order to save dryer. This will save energy during drying! detergent, water and time (the 13.5 Water hardness environment is protected too!). • Loading the appliance to the maximum If the water hardness in your area is high or capacity indicated for each moderate, we recommend that you use a...
Page 27
CAUTION! Do not clean the metal surfaces with Always follow the instructions that you chlorine-based detergent. find on the packaging of the product. Do not clean the drum with acidic 14.4 Descaling descaling products, scouring products containing chlorine or iron or steel wool. For a thorough clean: If the water hardness in your area is high 1.
Page 28
14.7 Cleaning the detergent dispenser 14.8 Cleaning the drain pump Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump if: • The appliance does not drain the water. • The drum does not turn. •...
Page 29
Proceed as follows to clean the pump: 180˚ ENGLISH...
Page 30
WARNING! Make sure that the impeller of the pump can rotate. If it does not rotate, contact the Authorised Service Centre. Make sure also that you tighten the filter correctly to prevent leakages. 14.9 Cleaning the inlet hose and the valve filter 45°...
15. CONSUMPTION VALUES 15.1 Introduction See the web link www.theenergylabel.eu for detailed information about Energy Label. The QR code on the energy label supplied with the appliance provides a web link to the product information sheet. Keep the energy label for reference together with the user manual and all other documents provided with this appliance.
Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.50 0.50 4.00 Time to Off/Standby mode is 15 minutes maximum. 15.4 Common programmes These values are indicative only. Programme rpm 1) Litres hh:mm °C Cottons 2.450 80.0 4:05 52.00 85.0...
Page 33
With some problems, the display shows an alarm code and the Start/ Pause button may flash continuously: Problem Possible solution • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this infor‐ The appliance does not fill mation, contact your local water authority.
Page 34
Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. The programme does not •...
Problem Possible solution • Make sure that the flap is in the correct position (UP for powder detergent - After the washing cycle, DOWN for liquid detergent). there are some detergent residues in the dispenser • Make sure you have used the detergent dispenser according the indications drawer.
Clean the filter regularly and, especially, if the alarm code appears on the display. 17.3 Programmes Programmes Load Product description Eco 40-60 8 kg White and coloured cottons. Normally soiled garments. Cottons 8 kg White cotton and coloured cotton. Synthetics 3 kg Synthetic items or mixed fabric items.