Table of Contents
Advertisement
Water Level
This appliance detects the amount of laundry
automatically, then sets the water level. However,
manually increasing the water level may be
required and recommended to avoid linting and
unbalanced errors when the load is bulky but
lightweight.
• Press Water Level option to adjust water level.
• When you select a wash programme, the water
level will be shown on the control panel.
• When water level is automatically detected, it
may differ depending on the amount of laundry
even though the same water level is indicated on
the control panel.
Rinse+
This option adds extra rinses to the selected
programme.
• Press Process button for 3 seconds repeatedly
to change the number of rinses. The number of
rinses is indicated on the display.
Temp.
Press the Temp. button repeatedly to select the
desired water temperature.
• The default water temperature is cold.
• The selected water temperature is confirmed by
the letters on the control panel.
- Cold water:
λ
- Warm water:
λ
and
- Hot water:
n
• When the washing machine is turned off and on
again, the water temperature is set to cold
water.
Using Basic Options
Process
When you need a wash+rinse+spin, spin only,
rinse+spin, rinse only, wash+rinse, wash only cycle,
these can be set manually.
• Press the Process button to select wash, rinse
and spin options as desired.
1
Press the POWER button.
n
2
Press the Process button until the icon lights
up.
• When you select a programme, the icon in
front of each option lights up.
3
Press the Water Level button to adjust the
water level according to the amount of laundry.
4
Add laundry into the drum.
5
Press the START/PAUSE button to start the
cycle(s).
6
Add the detergent into the detergent
dispenser and close the door.
NOTE
• When you set a washing cycle manually such as
rinse only, wash only or wash and rinse, the
water will not be drained out after the wash is
completed. If you wish to drain the water, select
a spin only cycle after the wash has completed.
• If a rinse only cycle is selected, the water supply
is started after detecting the load and this cycle
will start. However this cycle will start to supply
water of the selected water level if there is
already water in the drum.
• If you do not select or change the water level, the
water level will be set automatically.
Setting
Child Lock
Use Child Lock function to disable the controls.
This function can prevent children from changing
programmes or operating this appliance.
NOTE
• Once this function is set, all buttons are locked
except the POWER button.
OPERATION
25
Advertisement
Table of Contents
