Advertisement
Quick Links
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Electric shock
Refer to
hazard
instruction
manual
1.
SAFETY
1.1.
ELECTRICAL SAFETY
WARNING! This product is supplied without a mains cable. It must be installed by a qualified electrician.
‰
WARNING! It is the responsibility of the owner and the operator to read, understand and comply with the following: You must check all
‰
electrical products before use to ensure that they are safe. You must inspect power cables, plugs, sockets and any other connectors for
wear or damage. You must ensure that the risk of electric shock is minimised by the installation of appropriate safety devices. A Residual
Current Circuit Breaker (RCCB) should be incorporated in the main distribution board. We also recommend that a Residual Current Device
(RCD) is used. It is particularly important to use an RCD with portable products that are plugged into a supply which is not protected by an
RCCB. If in any doubt consult a qualified electrician. You must also read and understand the following instructions concerning electrical
safety:
1.1.1. The Health & Safety at Work Act 1974 makes owners of electrical appliances responsible for the safe condition of those appliances and
the safety of the appliance operators. If in any doubt about electrical safety, contact a qualified electrician.
1.1.2. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.3. Ensure that cables are always protected against short circuit and overload.
1.1.4. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that none are loose.
1.1.5. Important: Ensure that the voltage marked on the appliance matches the power supply to be used and that the plug is fitted with the
correct fuse.
▲
DANGER! If the power cable for this equipment is damaged, it must be replaced by a qualified electrician to avoid danger.
DO NOT pull or carry the appliance by the power cable.
8
DO NOT pull the plug from the socket by the cable.
8
DO NOT use worn or damaged cables, plugs or connectors. Immediately have any faulty item repaired or replaced by a qualified
8
electrician.
1.2.
FIXED APPLIANCE
The means of disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
9
1.3.
FIXED WIRING
The rated residual operating current does not exceed 30mA.
9
1.4.
GENERAL SAFETY
Please read this manual before operating this appliance.
9
1.5.
VISIBLY GLOWING RADIANT HEATERS
DO NOT use this heater with a programmer, timer, separate remote-control system or any other device that switches the heater on
8
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
WARNING! If the directions in this manual are not followed, an electric shock or fire may result causing property damage, personal
‰
injury or loss of life.
WARNING! The heater must be installed at least 1.8m above the floor.
‰
DO NOT store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other heating appliance.
8
Any required service other than filter maintenance should only be performed by an authorised service representative. Any other repairs
9
attempted by anyone other than an authorised service representative will void the warranty.
Use this heater only as described in this manual. Any other use is not recommended by the manufacturer and may cause fire, electric
9
shock, or injury to persons.
WARNING! This heater is hot when in use. To avoid burns, DO NOT let bare skin touch hot surfaces. Keep combustible materials, such
‰
as furniture, pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from
the sides and rear (Sides and rear restrictions apply to location dedicated heaters only).
WARNING! Extreme CAUTION is necessary when any heater is used by or near children or vulnerable and whenever the heater is left
‰
operating and unattended.
DO NOT operate any heater if it has malfunctioned. Disconnect power at service panel. Have heater inspected by a reputable
8
electrician before reusing.
To disconnect heater, turn controls to OFF at the heater. Turn the power OFF at the circuit distribution panel before disconnecting the
9
heater.
To prevent a possible fire DO NOT block heating elements.
9
WARNING! Ensure the heater is at least 1m from any object, 600mm from the ceiling and 1.8m above the floor.
‰
Familiarise yourself with the applications and limitations of the heater.
9
© Jack Sealey Limited
6000W HIGH EFFICIENCY INFRARED SHORT
WAVE WALL MOUNTING HEATER
MODEL NO:
Warning:
DO NOT
Hot surface
cover
Original Language Version
IWMH6000R
IWMH6000R Issue:2 (5) 15/07/24
Advertisement
Related Manuals for Sealey IWMH6000R
Summary of Contents for Sealey IWMH6000R
- Page 1 IWMH6000R MODEL NO: Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
- Page 2 Cleaning and user maintenance on the appliance shall not be made by children without supervision. Ensure the heater is in good order and condition before use. If in any doubt do not use the unit and contact your Sealey stockist.
- Page 3 4.2.1. ELECTRICAL SAFETY INFORMATION: It is important that the following information is read and understood. Sealey recommend that installation and repairs are carried out by a qualified electrician. IMPORTANT: The appliance must NOT be connected to the mains supply by means of a 13A plug and socket.
- Page 4 IMPORTANT: No Liability is accepted for incorrect use of this product. WARRANTY: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk...