Fallback Profile - Cisco Catalyst 3560X-24P Command Reference Manual

Cisco ios release 12.2(55)se

Hide thumbs Also See for Catalyst 3560X-24P:

Table of Contents

fallback profile

Use the fallback profile global configuration command on the switch stack or on a standalone switch to

create a fallback profile for web authentication. To return to the default setting, use the no form of this

Syntax Description

No fallback profile is configured.

Command Modes

Global configuration

Command History

Usage Guidelines

The fallback profile is used to define the IEEE 802.1x fallback behavior for IEEE 802.1x ports that do

not have supplicants. The only supported behavior is to fall back to web authentication.

After entering the fallback profile command, you enter profile configuration mode, and these

configuration commands are available:

This example shows how to create a fallback profile to be used with web authentication:

Switch# configure terminal

Switch(config)# ip admission name rule1 proxy http

Switch(config)# fallback profile profile1

Switch(config-fallback-profile)# ip access-group default-policy in

Switch(config-fallback-profile)# ip admission rule1

Switch(config-fallback-profile)# exit

Switch(config)# interface gigabitethernet 1/0/1

Switch(config-if)# dot1x fallback profile1

Switch(config-if)# end

You can verify your settings by entering the show running-configuration [interface interface-id]

privileged EXEC command.

Catalyst 3750-X and 3560-X Switch Command Reference

fallback profile profile

no fallback profile

Specify the fallback profile for clients that do not support IEEE 802.1x

authentication.

Modification

This command was introduced.

ip: Create an IP configuration.

access-group: Specify access control for packets sent by hosts that have not yet been authenticated.

admission: Apply an IP admission rule.

Catalyst 3750-X and 3560-X Switch Cisco IOS Commands