Table of Contents
Advertisement
Connecting to an LRE Port
The LED turns amber while STP discovers the network topology and searches for loops. This process
takes about 30 seconds, and then the port LED turns green.
If the LED is off, the target device might not be turned on, there might be a cable problem, or there might
be a problem with the adapter installed in the target device. See
solutions to cabling problems.
Step 5
Reconfigure and restart the target device if necessary.
Step 6
Repeat Steps 1 through 5 to connect each port.
Connecting to an LRE Port
Depending on the switch model, you can connect the LRE port to up to 8 or up to 24 LRE customer
premises equipment (CPE) devices through a patch panel. For information about which LRE CPE
devices are supported by the LRE switches, see
You can connect both Cisco 575 LRE CPE and Cisco 585 LRE CPE devices to your Catalyst 2950ST-8
Note
LRE or Catalyst 2950ST-24 LRE switch.
You can connect only the Cisco 576 LRE CPE 997 device to LRE ports on a Catalyst 2950ST-24 LRE 997
switch.
You can hot swap the CPE devices without powering down the switch or disrupting the other switch
ports.
Connection Guidelines
If telephone services, such as voice or Integrated Services Digital Network (ISDN), use the same cabling
as the LRE traffic, you must connect the LRE to a plain old telephone service (POTS) splitter. The
splitter routes LRE data (high-frequency) and voice (low-frequency) traffic from the telephone line to
the switch and private branch exchange (PBX) switch or public switched telephone network (PSTN).
If the other telephone services are connected through a PBX switch, you can use a Cisco LRE 48 POTS
Splitter. The PBX routes voice traffic to private telephone networks and the PSTN. For more information
about the Cisco LRE 48 POTS Splitter (PS-1M-LRE-48), see the Installation and Warranty Notes for the
Cisco LRE 48 POTS Splitter.
If the installation does not have a PBX, you need to use a homologated POTS splitter to connect to the
PSTN. For more information about homologated POTS splitters, contact your Cisco sales representative.
If a connection to a telephone network is not required, you do not need a splitter, and you can connect
the switch to the patch panel.
Catalyst 2950 Switch Hardware Installation Guide
2-30
Chapter 3, "Troubleshooting,"
Table 1-1 on page
1-3.
Chapter 2
Installation
for
OL-6156-01
Hide quick links:
Advertisement
Table of Contents
