Table of Contents
Advertisement
Assigning Switch Information
Default gateway (router) ___________.___________.___________._________
Enable secret password
Use this procedure to create an initial configuration for the switch:
Be sure the rollover cable is connecting a PC serial port to the switch
Note
console port. The data characteristics are 9600 baud, 8 data bits,
1 stop bit, and no parity. Use the supplied rollover cable and DB-9
adapter to connect a PC to the switch console port. You need to
provide a RJ-45-to-DB-25 female DTE adapter if you want to
connect the switch console port to a terminal. You can order a kit
(part number ACS-DSBUASYN=) containing that adapter from
Cisco. For console port and adapter pinout information, see the
"Cable and Adapter Specifications" section on page
Step 1
Enter Y at the prompt:
Continue with configuration dialog? [yes/no]: y
If this prompt does not appear, enter enable, and press Return. Enter setup, and
press Return to restart the setup program.
Step 2
Enter the switch IP address, and press Return:
Enter IP address: ip_address
Step 3
Enter the subnet mask (IP netmask) address, and press Return:
Enter IP netmask: ip_netmask
Enter Y to specify a default gateway (router):
Step 4
Would you like to enter a default gateway address? [yes]: y
Step 5
Enter the IP address of the default gateway, and press Return:
IP address of the default gateway: ip_address
Step 6
Enter a host name for the switch, and press Return:
Catalyst 3500 Series XL Hardware Installation Guide
2-26
Chapter 2
___________________________________________
Installing and Starting Up the Switch
B-4.
78-6456-04
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
