Table of Contents
Advertisement
Configuring the Switch with the CLI-Based
Setup Program
This appendix provides a quick installation and setup procedure for the switch module by using the
command-line interface (CLI).
For detailed installation procedures, see
Note
information, see
These are the major steps for a quick installation when using the CLI:
1.
2.
3.
Accessing the CLI Through the Console Port
You can access the CLI on a configured or unconfigured switch module by connecting the console port
of the switch module to the serial port on your PC or workstation and accessing the switch module
through a Telnet session.
Connecting to the Console Port
Obtain and make note of this information from your network administrator before you begin the switch
module installation:
•
•
•
•
•
•
•
OL-12246-01
Chapter 1, "Product Overview."
Accessing the CLI Through the Console Port, page C-1
Connecting to the Console Port, page C-1
Completing the Initial Configuration, page C-4
Switch IP address
Subnet mask (IP netmask)
Default gateway (router)
Enable secret password (encrypted)
Enable password (not encrypted)
Telnet password
SNMP community strings (optional)
A P P E N D I X
Chapter 2, "Switch Installation."
Cisco Catalyst Blade Switch 3120 for HP Hardware Installation Guide
C
For product overview
C-1
- Quick Links:
- Switch Module Features Overview
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
