Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for Asus V2-M2NC61S
Summary of Contents for Asus V2-M2NC61S
- Page 1 U2811 V-Series M2NC61S ASUS PC (Desktop Barebone) Installation Manual...
-
Page 2: Front Panel Features
Refer to the system user guide for installation details and other system information from ASUS website. Front panel features 5 . 2 5 - i n c h d r i v e bay cover 3 . 5 - i n c h d r i v e b a y... -
Page 3: Internal Components
Internal components M2N-NM Front panel cover ASUS motherboard 5.25-inch optical drive bays PCI Express x16 slot Hard disk drive bay 10. PCI Express x1 slot Floppy disk drive bay 11. PCI slots Power supply unit 12. Metal bracket lock CPU socket... -
Page 4: Removing The Side Cover And Front Panel Assembly
Removing the side cover and front panel assembly Remove the cover screws on the rear panel. Pull the side cover toward the rear panel until its hooks disengage from the chassis tabs. Set the side cover aside. Locate the front panel assembly hooks, then lift them until they disengage from the chassis. -
Page 5: Installing The Cpu Fan And Heatsink Assembly
Install the CPU to the socket, making sure that the CPU cornes with the gold triangle matches the socket corner with a small triangle. Push down he socket lever to secure the CPU. Installing the CPU fan and heatsink assembly Place the heatsink on top of the installed CPU, making sure that the heatsink fits properly on the retention module base. -
Page 6: Installing A Dimm
Installing a DIMM Locate the DIMM sockets in the motherboard. Unlock a DIMM socket by pressing the retaining clips outward. Align a DIMM on the socket such that the notch on the DIMM matches the break on the socket. Push the DIMM to the socket until the retaining clips snap inward. •... -
Page 7: Installing Storage Drives
Installing storage drives Optical drive Place the chassis upright, then remove the upper 5.25” drive bay metal plate cover. Insert the optical drive to the bay, then carefully push the drive until its screw holes align with the holes on the bay. Secure the optical drive with two screws on both sides of the bay. -
Page 8: Removing The Bay Covers And Reinstalling The Front Panel Assembly And Side Cover
For SATA HDD: Connect the SATA SATA signal and power plugs to the connectors at the back of the drive. For IDE HDD: Connect the IDE signal and power plugs to the connectors at the back of the drive. Removing the bay covers and reinstalling the front panel assembly and side cover If you installed an optical and/or floppy disk drive, remove the bay cover(s) on the front panel assembly before reinstalling it to the chassis.