Configuring An Snmp Name; Configuring An Snmp Trap Host - Cisco 11503 - CSS Content Services Switch Administration Manual
Content services switch
Hide thumbs
Also See for 11503 - CSS Content Services Switch:
- Configuration manual (250 pages) ,
- Hardware installation manual (184 pages) ,
- Getting started manual (142 pages)
Table of Contents
Advertisement
Defining the CSS as an SNMP Agent
Configuring an SNMP Name
Configuring an SNMP Trap Host
Cisco Content Services Switch Administration Guide
5-16
To set or modify the SNMP name for this system, use the snmp name command.
You can specify only one name. The syntax for this global configuration mode
command is:
snmp name "name"
Enter the SNMP name as the unique name assigned to a system by the
administrator. Enter a quoted text string with a maximum of 255 characters. The
standard name convention is the system's fully qualified domain name (for
example, sqa@arrowpoint.com).
For example:
(config)# snmp name "sqa@arrowpoint.com"
To remove the SNMP name for a system and reset it to the default of "Support",
enter:
(config)# no snmp name
To set or modify the SNMP host to receive traps from a CSS, use the snmp
trap-host command. You can specify a maximum of five hosts. The syntax for
this global configuration mode command is:
snmp trap-host ip_or_host community_name {snmpv2}
The variables and option for this command are:
ip_or_host - The IP address or host name of an SNMP host that has been
•
configured to receive traps. Enter an IP address in dotted-decimal notation
(for example, 192.168.11.1) or in mnemonic host-name format (for example,
myhost.mydomain.com).
community_name - The community name to use when sending traps to the
•
specified SNMP host. Enter an unquoted text string with no spaces and a
maximum of 12 characters.
snmpv2 - Specifies that traps be sent in SNMPv2 format.
•
Chapter 5
Configuring Simple Network Management Protocol (SNMP)
OL-5647-02
Advertisement
Table of Contents
