Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
Configuring the IP Routing Table
•
•
•
For handling IP packets on the out-of-band MNG port, the SCE platform maintains a static routing table.
When a packet is sent, the system checks the routing table for proper routing, and forwards the packet
accordingly. In cases where the SCE platform cannot determine where to route a packet, it sends the
packet to the default gateway.
SCE platform supports the configuration of the default gateway as the default next hop router, as well as
the configuration of the routing table to provide different next hop routers for different subnets (for
maximum configuration of 10 subnets).
The following sections illustrate how to use CLI commands to configure various parameters.
The following commands are relevant to IP routing tables:
•
•
•
•
•
•
•
How to Configure the Default Gateway
•
•
Options
The following option is available:
•
Step 1
From the SCE(config)# prompt, type ip default-gateway ip-address, and press Enter.
Enables privileged EXEC mode.
•
Configuring the Default Gateway: Example
The following example shows how to set the default gateway IP of the SCE platform to 10.1.1.1.
SCE(config)#ip default-gateway 10.1.1.1
OL-7827-12
How to Configure the Default Gateway, page 5-53
How to Add an Entry to the IP Routing Table, page 5-54
Displaying the IP Routing Table, page 5-54
ip default-gateway
ip route prefix mask next-hop
no ip route all
no ip route prefix mask
show ip route
show ip route prefix
show ip route prefix mask
Options, page 5-53
Configuring the Default Gateway: Example, page 5-53
ip-address—the IP address of the default gateway.
Enter your password if prompted.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
IP Configuration
5-53
Advertisement
Table of Contents
