Table of Contents
Advertisement
Chapter 21
Configuring Fibre Channel Routing Services and Protocols
This value must be the same on the switches on both ends of the interface.
Viewing FSPF Interface Statistics
To monitor FSPF interface statistics from the Fabric Manager, choose FC > FSPF on the menu tree and
click the Interface Stats tab.
To monitor FSPF interface statistics from the Device Manager, choose FC > FSPF and click the
Interface Stats tab.
Configuring Fibre Channel Routes
Each port implements forwarding logic, which forwards frames based on its FC ID. To configure the FC
ID for the specified interface and domain, you can configure the specified route (for example FC ID
111211 and domain ID 3) in the switch with domain ID 1.
Figure 21-4
Domain ID 1
Other than in VSANs, run time checks are not performed on configured and suspended static routes.
To configure Fibre Channel routes, perform the following steps:
From the Device Manager, choose FC > Routes. The dialog box displays routes for a single switch.
Step 1
Configure the attributes for the route.
Step 2
Step 3
To add a route from Device Manager, click Create in the dialog box.
You see the Create Route dialog box.
Click the button to the right of the Interface field and select the interface on which to configure the Fibre
Step 4
Channel route.
Complete the other fields on this window and click OK to add a route.
Step 5
Configuring Fibre Channel Route Flows
To view Fibre Channel flows and add a route flow, perform the following steps:
OL-7753-01
Fibre Channel Routes
fc1/1
Domain ID 3
FC ID 111211
Domain ID 7
Cisco MDS 9000 Fabric Manager Switch Configuration Guide
Configuring Fibre Channel Routes
21-7
Advertisement
Chapters
Table of Contents
Troubleshooting
