Maintaining The Switch; Installing Dust Covers In Empty Ports; Replacing An Sfp Transceiver - Cisco 9124 - MDS Fabric Switch User Manual
Fabric switch for hp c-class bladesystem
Hide thumbs
Also See for 9124 - Cisco MDS Fabric Switch:
- Configuration manual (1484 pages) ,
- Troubleshooting manual (560 pages) ,
- Installation manual (108 pages)
Table of Contents
Advertisement
The gateway address of the first switch should be set to whatever the gateway address is for the
subnet on which the first switch resides. See
Table 9
Connecting via a management station
Ethernet
FCIP
Gateway
Maintaining the Switch
The Cisco MDS 9124e Switch does not require any regular physical maintenance. However, it is
critical that environmental conditions, described in
prevent switch failure due to heat stress or improper air flow.
Installing dust covers in empty ports
The dust covers included in the Cisco MDS 9124e Switch shipping carton, (see
inserted in ports where SFPs are not installed. Installing dust covers ensures proper airflow and helps
reduce dust contamination of the switch.
Replacing an SFP transceiver
In some cases you might need to reinstall an SFP transceiver. To remove an SFP transceiver:
1.
Press and hold the cable release.
2.
Remove the cable from the transceiver.
3.
Pull the bail (wire handle) to release the transceiver.
4.
Grasp the bail, and gently but firmly pull the transceiver out of the port.
5.
Repeat this procedure for the remaining ports as required.
To install a replacement SFP:
1.
Make sure that the bail is in the unlocked position.
2.
Orient the SFP with the appropriate port. See
30
Managing the Switch
Management
First switch
station
192.168.1.09
192.168.1.10
192.168.65.09
192.168.65.10
192.168.1.10
any, not self
Table
9.
Second switch
204.1.1.1 1
192.168.65.1 1
192.168.1.10
"Environmental
Figure 7
and
Table
Third switch
204.1.1.12
192.168.65.12
192.168.1.10
considerations" are met to help
Figure
1) must be
10.
Hide quick links:
Advertisement
Table of Contents
