Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG OKO FAVORIT 40300
Summary of Contents for AEG OKO FAVORIT 40300
- Page 1 ÖKO_FAVORIT 40300 Dishwasher User Instructions...
- Page 2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
-
Page 3: Table Of Contents
Switching Off the Dishwasher ........ - Page 4 Connecting the Dishwasher ........
-
Page 5: Operating Instructions
• Keep all packaging away from children. • Keep all detergents in a safe place out of children’s reach. • The water in your dishwasher is not suitable for drinking. If there are still remnants of detergent in the appliance, there is a risk of burns! •... -
Page 6: Correct Use
• Only use detergents specifically designed for use in domestic dish- washers. • Do not put any solvents in the dishwasher. There is a risk of an explo- sion! • The anti-flood system provides dependable protection against dam- age due to leaks. -
Page 7: Disposal
Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. • Plastic parts are marked with standard international abbreviations: –... -
Page 8: Appliance Features And Control Panel
Operating Instructions Appliance Features and Control Panel Rubber Seal for Connecting the Water Feed to the Upper Spray Arm Spray Arms Water Hardness Switch Container for Salt Container for Rinse Aid Container for Detergent Rating Plate Filters... -
Page 9: Control Panel
The programme switch rotates during the wash pro- gramme and indicates the position that has been reached in the programme. Switch on the dishwasher and start a wash programme using the pro- gramme selector. Prior to using for the first time Prior to using for the first time, remove all the clips with which the dish racks are secured for transport. -
Page 10: Adjust The Water Softener
Operating Instructions Adjust the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 °d (German degrees) is softened with the... -
Page 11: Filling With Salt For The Water Softener
If the water hardness in your area is less than 4 °d, you do not need to use dishwasher salt. The green mark will then not be visible. The func- tion of the appliance is not impaired. -
Page 12: Filling With Rinse Aid
– When the window indicator has a dark centre surrounded by a light ring. If there is sufficient rinse aid in the container, the indicator win- dow is completely dark. The rinse aid compartment is on the inside of the dishwasher door. 1. Open the door. 2. Press the rinse aid compartment release button with your finger. -
Page 13: Adjusting Rinse Aid Dosing
1 to 6. Only change the setting if streaks, milky spots or dried on water marks are visible on glasses or crockery. 1. Open the door of the dishwasher. 2. Press the rinse aid compartment release button with your finger. -
Page 14: In Daily Use
– Dishes and items of cutlery must not lie inside one another, or cover each other are of limited suitability: • Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher- safe by the manufacturer. • Glazed patterns may fade if machine washed frequently. -
Page 15: Loading Cutlery
– To avoid damage to glasses, they must not touch – Do not lay small objects (e.g. lids) in the cutlery rack Loading Cutlery Long bladed knives stored in an upright position are a potential haz- ard. Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper bas- ket. -
Page 16: Loading Pans, Frying Pans And Large Plates
Load large and heavily soiled dishes in the lower rack. To ease the loading of large items at some dishwasher-models the two rows of prongs for the right-hand plate insert can be folded down: 1. Slightly lift the right plate insert. -
Page 17: Loading Cups, Glasses And Coffee Services
Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. •... -
Page 18: Filling With Detergent
Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. The detergent compartment is on the inside of the dishwasher door. 1. If the lid is closed: press release button (1). The lid springs open. -
Page 19: Bio Wash Programmes And Concentrated Detergents
Bio Wash Programmes and Concentrated Detergents Based on their chemical composition, dishwasher detergents can be split into two basic types: – Conventional, alkaline detergents with caustic components – Weak alkaline concentrated detergents with natural enzymes. The use of BIO wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;... -
Page 20: Selecting The Wash Programme (Programme Table)
Dessert Dishes and Coffee Dish Types Service with delicate glasses • lightly soiled Used dishes that are collected in the dishwasher and are to be washed at a later point in gents. time. ò ò ECON. BIO PRE WASH ECONOMY PRE WASH BIO 50°... -
Page 21: Starting The Wash Programme
Starting the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Close dishwasher door. 4. Turn the programme selector clockwise to A Table“). -
Page 22: Switching Off The Dishwasher
• The dishes should therefore be allowed to cool down before removing them from the appliance, as hot dishes can be sensitive to knocks. • Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down. -
Page 23: Care And Cleaning
Blocked filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove. -
Page 24: What To Do, If
What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a... -
Page 25: There Are Problems With The Operation Of The Dishwasher
– Detergent was not used or too little was used. Possible Cause The anti-flood system has been triggered. The door of the dishwasher is not closed properly. Mains plug is not plugged in. Insert mains plug. House fuse in defective. - Page 26 Operating Instructions – In the case of scale deposits on the dishes: the special salt container is empty or the water softener is incorrectly adjusted. – The drain hose is incorrectly laid. The dishes are wet and dull. – Rinse aid was not used. –...
-
Page 27: Technical Data
1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. 850 x 600 x 600 (H x W x D in mm) 54 Kg 820 –... -
Page 28: Notes For Test Institutes
Operating Instructions Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table). -
Page 29: Installation And Connection Instructions
Free-Standing Appliances • can be set up as stand-alone without additional installation. If the dishwasher is set up next to a gas or coal cooker, a heat- insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work surface (depth 57.5 cm). - Page 30 (5). • The dishwasher must also be screwed on tightly to the work surface or to the adjoining units. This is absolutely necessary so that its sta- bility is guaranteed according to VDE regulations.
-
Page 31: Connecting The Dishwasher
• The dishwasher can be connected to cold and hot water supplies up to max. 60 °C. • The dishwasher must not be connected to open hot water appliances or instantaneous water heaters. -
Page 32: Water Drain
Installation and Connection Instructions Water drain Drain hose The drain hose must not be kinked, crushed or entangled. • Connecting the drain hose: – Maximum permitted height: 1 metre. – Minimum required height 30 cm above the lower edge of the machine. -
Page 33: Leak Prevention System
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the drain pump switches on. By this means water can neither escape nor overflow. -
Page 34: Electrical Connection
Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed. -
Page 35: Connections
Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation. -
Page 36: Guarantee Conditions
Guarantee Conditions GUARANTEE CONDITIONS Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar doc- umentation. -
Page 39: Service & Spare Parts
SERVICE & SPARE PARTS If you wish to purchase spare parts or require an engineer, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Centre covering your post code area. When you contact the Service Centre they will need the following information: Your name &... - Page 40 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 945 495 - 00 - 0801 Subject to change without notice...