Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AEG 60820
Summary of Contents for AEG 60820
- Page 1 FAVORIT 60820 Dishwasher User Instructions...
- Page 2 Dear customer, Please read these user instructions carefully. Please observe the safety instructions on the first few pages of these user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance.
-
Page 3: Table Of Contents
Switching Off the Dishwasher ........ - Page 4 Built-Under Dishwasher ........
-
Page 5: Operating Instructions
• Keep all packaging away from children. • Keep all detergents in a safe place out of children’s reach. • The water in your dishwasher is not suitable for drinking. If there are still remnants of detergent in the appliance, there is a risk of burns! •... -
Page 6: Correct Use
• Only use detergents specifically designed for use in domestic dish- washers. • Do not put any solvents in the dishwasher. There is a risk of an explo- sion! • The anti-flood system provides dependable protection against dam- age due to leaks. -
Page 7: Disposal
Disposal Disposing of the Packaging Material Dispose of the dishwasher packaging material correctly. All the packag- ing materials used are harmless to the environment and can be recy- cled. • Plastic parts are marked with standard international abbreviations: –... -
Page 8: Appliance Features And Control Panel
Operating Instructions Appliance Features and Control Panel Top Spray Arm Rubber Seal for Connecting the Water Feed to the Middle Spray Spray Arms Water hardness switch Container for Salt Container for Detergent Container for Rinse Aid Filters Rating Plate... -
Page 9: Control Panel
– whether the rinse aid supply is switched on/off. – the start delay that is set. – how long the current wash programme can be expected to last. – which fault has occurred on the dishwasher. Indicators have the following significance: SALT... -
Page 10: Prior To Using For The First Time
Operating Instructions The FILTER indicator is intended to remind you to check the filters in the dishwasher from time to time and, if necessary, to clean it. The indicator illuminates at regular intervals, independent of the amount of soiling of the filters. -
Page 11: Adjusting The Water Softener
Adjusting the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dishwasher is fitted with a water softener in which tap water from a hardness of 4 °d (German degree) is softened with the aid... - Page 12 Operating Instructions Adjust the water softener to the hardness of the water in your area as stated in the table: 1. The dishwasher must be switched off. 2. Manual adjustment: Open the dishwasher door. 3. Remove the lower rack from the dishwasher.
-
Page 13: Filling With Salt For The Water Softener
5. Clean any salt remnants on the container opening. 6. Turn the lid clockwise to the stop, otherwise dishwasher salt will leak into the wash water, this could lead to poor wash results. To avoid this run a rinse programme after filling the salt container with special salt. -
Page 14: Rinse Aid
Only use rinse aid specifically designed for domestic dishwashers. Never fill the rinse aid container with any other substance (e.g., vinegar con- centrate or dishwasher cleaning agent) as this would damage the appli- ance. Switching Rinse Aid Supply On and Off 1. -
Page 15: Filling With Rinse Aid
– prior to using the dishwasher for the first time – when the RINSE AID indicator on the control panel is illuminated. The rinse aid compartment is on the inside of the dishwasher door. 1. Open the door. 2. Press the rinse aid compartment release button with your finger. -
Page 16: Adjusting Rinse Aid Dosing
In Daily Use • Check the salt and rinse aid levels. • Load cutlery and dishes into the dishwasher • Fill with dishwasher detergent • Select a wash programme suitable for the cutlery and dishes • Start the wash programme... -
Page 17: Loading Cutlery And Dishes
– Do not lay small objects (e.g. lids) in the cutlery rack Operating Instructions are of limited suitability: • Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher- safe by the manufacturer. • Glazed patterns may fade if machine washed frequently. -
Page 18: Loading Cutlery
Operating Instructions Loading Cutlery Long bladed knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be posi- tioned horizontally in the upper basket. Take care when loading or unloading sharp items such as knives. Place knives, small spoons and small forks in the cutlery tray. -
Page 19: Loading Pans, Frying Pans And Large Plates
On some models of dishwasher it is possible to open the cutlery basket. To ensure that the cutlery basket cannot open on removal from the appliance, you should always hold both parts of the two part handle. 1. Place the cutlery basket on a table or work surface 2. -
Page 20: Loading Cups, Glasses And Coffee Services
Operating Instructions 2. Fold the plate insert to the left. Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange items of crockery on the folding cups racks so that they are offset from each other and water can reach all items. -
Page 21: Adjusting The Height Of The Upper Basket
Adjusting the Height of the Upper Basket With upper basket raised With upper basket lowered The height of the basket can also be adjusted when it is loaded. Lowering the Upper Basket: 1. Pull the upper basket out completely. 2. Holding the upper basket at the rear right, lift it as far as it will go and then lower it vertically. -
Page 22: Filling With Detergent
Please observe the manufacturer's dosing and storage recommenda- tions as stated on the detergent packaging. The detergent compartment is on the inside of the dishwasher door. 1. If the lid is closed: press release button (1). The lid springs open. -
Page 23: Concentrated Detergent
Concentrated Detergent Based on their chemical composition, dishwasher detergents can be split into two basic types: – conventional, alkaline detergents with caustic components – low alkaline concentrated detergents with natural enzymes. The use of 50 °C wash programmes in conjunction with concentrated detergents reduces pollution and is good for your dishes;... -
Page 24: Selecting The Wash Programme (Programme Table)
In addition to the wash programmes given in the table there is the special programme PRE WASH. Using this programme you can give an initial wash to dishes that are to be stored in the dishwasher ready to be washed later. The special programme PRE WASH lasts 12 minutes and uses 4 litres of water and less than 0.1 kWh of energy. -
Page 25: Start The Wash Programme
Start the Wash Programme 1. Check that when the dishes and cutlery are loaded into the dishwasher the spray arms are free to rotate. 2. Open the tap fully. 3. Shut the door. 4. Press the ON/OFF button. The ON/OFF button indicator illuminates. -
Page 26: Setting Or Changing The Delay Start Timer
Operating Instructions 1. Open the door of the dishwasher. The wash programme stops. 2. The indicator for the programme that is currently running extinguishes. 3. Close the door. The wash programme continues. Cancelling the wash programme 1. Press the button for the current wash programme and hold it pressed. -
Page 27: Load Sensing - Sensor Logic
• The dishes should therefore be allowed to cool down before removing them from the appliance, as hot dishes can be sensitive to knocks. • Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and can cool down. -
Page 28: Care And Cleaning
Dirty filters will give poor wash results. 1. Open the door, remove the lower rack. 2. The dishwasher filter system com- prises a coarse/fine filter, microfilter and a flat filter. Unlock the filter sys- tem using the handle on the microfil- ter, and remove. -
Page 29: What To Do, If
What to do, if ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call an engineer to resolve a of fault listed here, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is in guarantee. -
Page 30: Error Messages
Operating Instructions ...Error messages • If fault code (2 is displayed on the multi-display or the WATER indi- cator is illuminated, you can probably rectify the fault yourself. After rectifying a (2 fault and a fault related to the WATER indica- tor, press the button for the wash programme that has been started. -
Page 31: There Are Problems With The Operation Of The Dishwasher
– The drain hose is incorrectly laid. Possible Cause The door of the dishwasher is not closed properly. Mains plug is not plugged in. Insert mains plug. House fuse is defective. -
Page 32: Technical Data
1-10 bar (=10-100 N/cm = 0.1-1.0 MPa) Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. 850 x 600 x 600 (H x W x D in mm) 54 Kg 820 –... -
Page 33: Notes For Test Institutes
Notes for Test Institutes Testing in accordance with EN 60704 must be carried out with the appliance fully loaded and using the test programme (see Programme Table). Tests in accordance with EN 50242 must be carried out when the salt dispenser and rinse aid container have been filled with salt and rinse aid respectively and using the test programme (see Programme Table). -
Page 34: Installation And Connection Instructions
Free-Standing Appliances can be set up as stand-alone without additional installation. If the dishwasher is set up next to a gas or coal cooker, a heat- insulating, non-flammable plate must be mounted between the dishwasher and the cooker, flush to the top edge of the work surface (depth 57.5 cm). - Page 35 1 cm to the rear (2). 3. Lift the work surface at the front (3) and remove. If the dishwasher is later used as a free-standing appliance, the original work surface must be re-mounted. The plinth on free-standing appliances is not adjustable.
-
Page 36: Connecting The Dishwasher
• The dishwasher must be connected to a cold water supply. • The dishwasher must not be connected to open hot water appliances or instantaneous water heaters. Permitted water pressure... -
Page 37: Water Inlet Hose With Safety Valve
If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water and the draining pump in the dishwasher is switched on. Please take care when installing the water inlet hose: –... -
Page 38: Water Drain
If the dishwasher is fitted at a high position If the dishwasher is installed at a high level, and the drainhose connec- tion is less than 30 cm from the bottom of the appliance, adapter kit ET 111099520 must be fitted. -
Page 39: Leak Prevention System
Installation and Connection Instructions Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention system, the AQUA CONTROL SYSTEM. In the event of a fault, the safety valve immediately interrupts the sup- ply of water to the appliance and the drain pump switches on. -
Page 40: Electrical Connection
Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed. -
Page 41: Connections
Connections The water inlet and drain hoses, as well as the mains cable must be connected beside the dishwasher as there is insufficient space behind the appliance. The plumbing and electrical installation example given below can only be regarded as a recommendation. -
Page 42: Guarantee Conditions
Guarantee Conditions GUARANTEE CONDITIONS Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar doc- umentation. -
Page 43: Service And Spare Parts
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to pur- chase spare parts, please contact Service Force by telephoning: 08705 929 929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. - Page 44 AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG 822 946 397 - 00 - 0602 Subject to change without notice...