Table of Contents
Advertisement
3.
Hold the handle of a drive tray. Pull it upward until it is on a 90-
degree angle with the tray and you hear a click. You may need
to exert force to pull up the tray handle.
4.
Pull out the drive tray.
Figure 3-14
Pulling Out a Hot-swap Drive Tray
5.
Remove the terminators and the drive ID on the wide SCSI drive
that you wish to install.
For a narrow SCSI drive, remove the terminators only, then set
the SCSI ID on the drive.
Make sure that you have closed J4 P3 pins
on the backplane board for additional SCSI
IDs. See section 3.4 for information on
setting the drive ID.
3-14
AcerAltos 19000Pro4 System Guide
Advertisement
Table of Contents
