Table of Contents
Advertisement
Warnings
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
For connections outside the building where the equipment is installed, the following ports must be
Warning
connected through an approved network termination unit with integral circuit protection.
10/100/1000 Ethernet Statement 1044
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Warning
recommended ambient temperature of:
140°F (60°C) Statement 1047
This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is
Warning
suitably designed for those specific environmental conditions that will be present and appropriately
designed to prevent personal injury resulting from accessibility to live parts. The interior of the
enclosure must be accessible only by the use of a tool. The enclosure must meet IP 54 or NEMA type
4 minimum enclosure rating standards. Statement 1063
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
For U.S. installations, refer to national electrical code ANSI/NFPA 70.
Note
Cisco IE 3010 Switch Hardware Installation Guide
2-2
Chapter 2
Switch Installation
78-19581-01
Advertisement
Table of Contents
