Completing The Parts Replacement - Lenovo ThinkCentre M71e Hardware Maintenance Manual
Machine types: 3129, 3132, 3133, 3134, 3136, 3140, 3141, 3143, 3146, 3147, 3150, 3154, 3156, 3157, 3166, 3167, 3169, 3171, 3175, 3176, 3177, 5033, 5036, 5039, 7338, and 7339
Hide thumbs
Also See for ThinkCentre M71e:
- (142 pages) ,
- User manual (140 pages) ,
- Benutzerhandbuch (138 pages)
Table of Contents
Advertisement
9. Install the new system fan assembly by aligning the new rubber mounts that came with the new system
fan assembly with the corresponding holes in the chassis, and then push the rubber mounts through the
holes. Then, carefully pull on the tips of the rubber mounts from the bottom until the new system fan
assembly is secured in place.
Figure 77. Installing the system fan assembly
10. Connect the new system fan assembly cable to the system fan connector on the system board. See
"Locating parts on the system board" on page 78.
11. Reinstall the hard disk drive. See "Replacing the hard disk drive" on page 121.
12. To complete the installation or replacement, go to "Completing the parts replacement" on page 141.
Completing the parts replacement
After completing the installation or replacement for all parts, you need to close the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 43.
To close the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 110 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it. To reinstall the front bezel, align the three tabs on
the front bezel with the corresponding holes in the chassis and pivot the front bezel inwards until
it snaps into position.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
4. Lower the optical drive bay.
5. Close the computer cover.
.
Chapter 9
Replacing FRUs (Machine Types: 3132, 3134, 3140, 3143, 3147, 3154, 3157, 3167,
3171, 3176, 5033, 5039, and 7339.)
141
Hide quick links:
Advertisement
Table of Contents
