Frequently Asked Questions - Linksys WET54G V3 User Manual

2.4ghz 802.11g wireless-g ethernet bridge

Hide thumbs Also See for WET54G V3:

Table of Contents

Wireless-G Ethernet Bridge

4. The Bridge-enabled PC won't communicate with a wireless-enabled PC or printer.

Perform the following steps:

• Check that the wireless-enabled PC or printer is on the same wireless network as the PC using the Bridge.

• Make sure that the SSID and network mode are the same for all devices connected to the same wireless

network.

• If the wireless LAN settings are okay, make sure that all the devices are on the same IP network.

5. The Web-based Utility won't open.

Make sure you correctly entered the Bridge's IP address in the Address field of your web browser. If you are

not sure what the Bridge's IP address is, then run the Setup Wizard. Follow the on-screen instructions until

you see a screen that lists all the Wireless-G Ethernet Bridges on your network. Select the Bridge you want to

access, and its IP address will appear in the Status box. Enter this IP address in your web browser's Address

field. For details, refer to "Chapter 5: Setting Up the Wireless-G Ethernet Bridge."

6. The Web-based Utility does not recognize my password.

The password is case-sensitive. Make sure that you are using the correct case(s) when entering the

password. If you forget your password, you can push the Bridge's Reset button. This will reset the password

to the default setting; however, all other Bridge settings will be reset to the factory defaults as well. To use

the default setting, enter admin in the Password field.

7. After I make changes through the Web-based Utility, the new settings aren't displayed on-screen.

Click the Refresh button of your web browser. If the new settings aren't displayed, then unplug the power

adapter from the Bridge. Plug the power adapter back in, and then click the Refresh button again.

Frequently Asked Questions

What is the IEEE 802.11g standard?

It is one of the IEEE standards for wireless networks. The 802.11g standard allows wireless networking hardware

from different manufacturers to communicate, provided that the hardware complies with the 802.11g standard.

The 802.11g standard states a maximum data transfer rate of 54Mbps and an operating frequency of 2.4GHz. It is

backward compatible with 802.11b devices.

What is the IEEE 802.11b standard?

It is one of the IEEE standards for wireless networks. The 802.11b standard allows wireless networking hardware

from different manufacturers to communicate, provided that the hardware complies with the 802.11b standard.

The 802.11b standard states a maximum data transfer rate of 11Mbps and an operating frequency of 2.4GHz.

Appendix A: Troubleshooting

Frequently Asked Questions

Table of Contents