Online Installation And Removal Of The T1 Or E1 Feature Card - Cisco AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle Installation Manual
Universal gateways
Hide thumbs
Also See for AS5400XM - Universal Gateway Voice High-Density Easy Order Bundle:
- Quick start manual (69 pages) ,
- Regulatory compliance and safety information manual (68 pages) ,
- Installing manual (16 pages)
Table of Contents
Advertisement
Online Installation and Removal of the T1 or E1 Feature Card
Figure 3-3
Note
Each T1 or E1 feature card provides physical line termination for multiple DS-0 channels and uses
onboard HDLC controllers to terminate digital (ISDN) calls. For network specifications, see
and
Table 3-1
Description
Line rate
Data rate (per port)
Standards
Input impedance
Table 3-2
Description
Line rate
Data rate (per port)
Input impedance
Online Installation and Removal of the T1 or E1 Feature Card
To remove a feature card without dropping any calls or connections, you will need to take the feature
card out of service by using the busyout command to disable the feature card. The busyout command is
executed on a per–feature card basis and will disable the card after waiting for the active services to
terminate.
If there are active calls on the feature card after you execute the busyout command, wait for the calls to
drop. To view the status of the termination process, use the show busyout command.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
3-2
8-Port T1 or E1 Feature Card
The Cisco AS5350XM and Cisco AS5400XM universal gateways each support only one type of
WAN feature card at a time. See
Table
3-2. You can use the bantam jack ports on the feature card to monitor a line.
T1 Feature Card Network Specifications
Specification
1.544 Mbps
number x 56 or number x 64 kbps, where number = 1 to 24
AT&T Pub. 62411, 54016, and 43081, and ANSI T1.403
100 ohm per port
E1 Feature Card Network Specifications
Specification
2.048 Mbps
number x 56 or number x 64 kbps, where number = 1 to 31.
75 or 120 ohm per port
Note
Chapter 7, "Troubleshooting,"
The factory default setting for the E1 ports is 120 ohm. For
information about changing the impedance, see the
Input Impedance for the E1 Feature Card" section on page
Chapter 3
T1 and E1 Feature Cards
for more information.
Table 3-1
"Configuring
3-11.
78-17406-01
Advertisement
Table of Contents
Troubleshooting
