Operating and Installation instructions Steam oven DG 5051 DG 5061 en - GB To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.
Any other use is not supported by the manufacturer and could be dangerous. Miele cannot be held liable for damage resulting from incorrect or improper use or operation of the appliance. This steam oven is not intended for...
Page 6
Warning and Safety instructions Safety with children Technical safety Activate the system lock to ensure Before installation, check the steam that children cannot switch on the oven for visible signs of damage. Do appliance inadvertently. not install and use a damaged appliance.
Page 7
The manufacturer cannot be held liable for unauthorised work. If the connection cable is damaged, it must be replaced with a special connection cable of type H 05 V V-F (pvc insulated), available from the Miele Spare Parts Department.
Warning and Safety instructions Correct use Do not leave cooked food in the oven and do not use any cooking Use heat-resistant pot holders or containers which are susceptible to gloves when using the appliance. Do corrosion as this could lead to not let them get damp or wet, as this corrosion in the appliance.
Page 9
Warning and Safety instructions When using an electrical appliance, The manufacturer cannot be held e.g. a hand-held food blender, near the liable for damage caused by steam oven, ensure that the cable of the electrical appliance does not come non-compliance with these Warning into contact with the hot appliance.
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled.
Guide to the appliance Front view a Control panel i Steam inlet b Ventilation outlet j Drip channel in the oven c Door seal k Floor heater d Steam channel l Temperature sensor e Compartment for water container m Steam outlet f Water container (with insert) g Contact point for water container h Shelf levels...
Guide to the appliance Accessories supplied The accessories supplied with your appliance as well as a range of optional ones are available to order from Miele (see "Optional accessories"). Condensate tray DGG 17 To catch excess moisture 325 x 350 x 40 mm (W x D x H)
Description of the functions Controls Function selector You select the function you want by turning the function selector (see "Operation / Functions"). Temperature selector You can use the temperature selector to alter the recommended temperature for the function selected in 1° steps within the permitted range (see "Operation / Setting the temperature") The function selector and the temperature selector can be...
Description of the functions Display The following symbols will appear in the display in addition to the text: Symbol Meaning A maximum of 2 options can be shown in the display. These arrows indicate if more than two options are available. - - - A dotted line will appear under the last option available.
Description of the functions Condensate tray When you are using perforated containers, place the condensate tray on the floor of the appliance to collect any drops of liquid and allow them to be removed easily. Water container The maximum water level is 1.2 litres, the minimum 0.75 litres. The water level markers are located inside and outside the container.
Description of the functions Heating-up phase During the heating-up phase the oven compartment is heated to the set temperature. The display will show the temperature of the cooking compartment as it rises. The duration of the heating-up phase will depend on the quantity and the temperature of the food.
Before using for the first time Setting up the appliance for using for the first time The appliance will switch on automatically when it is connected to the electricity supply. Welcome screen A welcome screen will appear in the display and you will then be requested to select some basic settings which are needed to set up the appliance up for using for the first time.
Page 19
Before using for the first time Clock format The request to select a Clock format will appear. The default setting for the clock is 24 h. ^ Touch the ; or ? sensor until the clock format you want appears highlighted in the display. Confirm with "OK".
Before using for the first time Please stick the extra data plate for the appliance supplied with this documentation in the space provided in the "After sales service" section of this booklet. Cleaning for the first time Remove any protective foil and adhesive labels. Water container Take the water container out of the appliance and remove the insert (see "Cleaning and care / Water container").
Before using for the first time Setting the correct boiling point for water The boiling point for water at a high altitude above sea level will be lower than the boiling point for water at sea level. To adjust the boiling point for the altitude in your area, fill the water container with mains tap water (see "Operation / Preparing the appliance for use") and then run the Cook universal 100 °C programme for 15 minutes.
Operation Functions Please refer to the "User instructions" booklet supplied with your appliance for more information on the following functions as well as tips on how to use your steam oven. Symbol Function / Menu Recommended Temperature temperature range Appliance is switched off Cook universal °C: 100 °C: 40 - 100...
Operation Preparing the appliance for use ^ Fill the water container with mains tap water up to at least the "min" marker. You do not need to remove the insert. Only use mains tap water. Never use distilled or mineral water or other liquids.
Operation Setting a cooking duration ^ Set the hours you want by touching ; (upwards) or ? (downwards), or touch "OK" if you want to set a duration of 59 minutes or less. Cook universal 100 °C 0:00 h : min ^ Set the minutes you want by touching ;...
Operation At the end of the duration At the end of the cooking duration an audible tone will sound and "Programme finished" will appear in the display. ^ Switch the appliance off by turning the function selector to "0". The fan will continue to run for a while after the oven has been switched off.
Operation After use ^ Remove the condensate tray and empty it. ^ Remove the water container by pushing it upwards slightly as you take it out of the appliance. Empty it. ^ After each use, clean and dry the whole appliance as described in "Cleaning and care".
Operation During operation Interrupting operation Operation is interrupted as soon as the door is opened. The heating will be switched off and the cooking duration remaining stored in memory. Steam will escape when the door is opened. Step back from the steam oven and wait until the steam has dissipated.
Operation Changing the duration You can alter the cooking duration at any time during operation. ^ Touch ; or ?. Cook universal 6:00 min. Duration Back # ^ Confirm with "OK". Duration 0:05 h : min (0:00 - 9:59 h) ^ Use the ;...
Operation Automatic programmes The weight entry in the Automatic programmes refers to the weight per piece. For example, you can cook just one piece of salmon weighing 250 g or 10 pieces of salmon weighing 250 g at the same time. ^ Fill the water container with fresh tap water and push it into the appliance.
Additional functions Start time You can delay the start of a programme. The appliance then switches on automatically. This is not possible on the "Descale" programme F. With "Start time" you enter the time of day at which you want the programme to start.
Additional functions Minute minder The minute minder can be used to time any activity in the kitchen, e.g. boiling eggs. You can also use the minute minder when a programme is running, e.g. as a reminder to stir a dish or add seasoning etc.
Additional functions Pre-heat Your appliance has a pre-heating function. This heats the oven interior to approx. 40 °C. The heating-up time is then shorter as the oven interior is pre-heated and therefore the cooking process takes less time. The appliance is delivered with the pre-heating function deactivated.
Additional functions System lock The system lock prevents the appliance being switched on unintentionally, by children for example. The appliance is delivered with the system lock deactivated (factory default setting). If you wish to use it you will need to alter the setting (see "Settings / Safety").
Settings Some of the standard steam oven settings (factory default settings) have an alternative which you can select if required. You can alter several settings one after the other. ^ Turn the function selector to the Settings menu. ^ Select the sub menu you want. ^ Select the option you want.
Settings Pre-heat This function can be activated or deactivated. Recommended temperatures If you frequently change a recommended temperature it may be a good idea to change it permanently. You can change the temperatures within the permitted range. Water hardness The steam oven is set at the factory to water hardness setting IV (Very hard 4).
Settings Safety Once the setting under "System lock" has been changed to "On", the appliance cannot be operated. Temperature format You can choose for the temperature to be shown in °C or °F. Showroom programme This programme is for dealers who want to demonstrate the appliance without the heating working.
Cleaning and care Miele offer a range of branded cleaning and conditioning products. See "Optional accessories". Do not use a steam cleaning appliance to clean this appliance. The steam could reach the electrical components and cause a short circuit. Switch the appliance off and allow it to cool down to a safe temperature before cleaning.
If this is not done, it might become impossible to remove and could cause the surface to alter or discolour. Clean the front using a damp Miele microfibre E-cloth or with a clean sponge and a solution of hot water and washing-up liquid.
Replace the door seal with a new one if it becomes porous or brittle. Door seals can be ordered from the Miele Spare Parts Department. Drip tray, rack and cooking containers Wash and dry the condensate tray, rack and cooking containers after each use.
Cleaning and care Water container Remove, empty and dry the water container after each use. ^ Release the insert by pushing the catches on the sides in towards each other and the pull it out of the container. ^ After cleaning, dry both parts of the insert thoroughly before replacing it in the water container.
Coupling seals can be ordered from the Miele Spare Parts Department. Only use the silicone grease supplied. On no account must margarine or oil or any other domestic grease or fat be used, as these can cause the seal to swell.
Cleaning and care F Descaling For optimum cleaning results we recommend that you use Miele descaling tablets to descale your steam oven (see "Optional accessories"). A proprietary citric acid based descaling agent can also be used. Follow the manufacturer’s instructions on the packaging.
Page 43
Cleaning and care ^ Remove the water container and empty it. Remove the insert. ^ Rinse the water container and the insert thoroughly. ^ Replace the insert and fill the water container with 1 litre of fresh tap water. Push the water container into the appliance until it connects.
Cleaning and care Removing and refitting the door It is much easier to clean the steam oven interior if you remove the door first. To remove the door ^ Open the door fully. ^ Flip up the release levers in front of the door hinges. ^ Slowly close the door until the raised levers are touching the frame.
Reset the trip switch in the mains fuse box, and switch the appliance back on. If it still will not switch on, contact a qualified electrician or the Miele Service Department..the appliance is in demo mode. The appliance will not heat up if it is in demo mode. See "Settings / Showroom programme".
Page 46
– the door seal is damaged, e.g. cracks can be seen. The seal must be replaced with a new one. If this does not solve the problem, call the Miele Service Department.
Page 47
– Lightly lubricate the coupling seal on the water container with silicone grease, as described in "Cleaning and care / Water container / Coupling seal". If the appliance still will not start, switch it off and contact the Miele Service Department. – Other fault messages: Call the Service department.
These products can be ordered at: or from Miele (see back cover for contact details) or from your Miele dealer. Cooking containers There is a wide range of perforated and solid cooking...
Page 49
Optional accessories DGGL 5 Perforated cooking container Gross capacity 2.5 litres / Usable capacity 2.0 litres 325 x 175 x 65 mm (W x D x H) DGGL 6 Perforated cooking container Gross capacity 4.0 litres / Usable capacity 2.8 litres 325 x 175 x 100 mm (W x D x H) DGG 7 Solid cooking container...
325 x 350 x 40 mm (W x D x H) Rack For placing your own cooking containers on Cleaning and care products Miele descaling tablets 6 tablets For descaling the water container Ceramic and stainless steel hob cleaner 250 ml Removes discolouration from the floor heater caused by drops of liquid.
Multi-purpose casserole dish KMB 5000-S Die-cast aluminium casserole dish with anti-stick surface and stainless steel lid. Also suitable for use on induction hobs and in all Miele ovens. Not suitable for use on gas hobs. Maximum capacity: 2.5 kg Dimensions: 325 x 260 x 65 mm (W x D x H)
Safety instructions for installation Before connecting the appliance, make sure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. This data must correspond in order to avoid the risk of damage to the appliance. Consult a qualified electrician if in any doubt.
Appliance and building-in dimensions Installation in a tall unit * Appliances with glass front ** Appliances with metal front a Steam oven b Building-in recess c Inlet for mains connection cable to the appliance d Recommended position for electrical socket. Important: Do not position behind the appliance! e Mains connection cable...
Appliance and building-in dimensions Installation in a base unit If the steam oven is being installed underneath a hob, please follow the instructions for building in the hob and also take the building-in height for the hob into account. * Appliances with glass front ** Appliances with metal front a Steam oven b Building-in recess...
Appliance and building-in dimensions Installation in a tall unit in combination with an oven * Appliances with glass front ** Appliances with metal front a Steam oven b Building-in recess c Inlet for mains connection cable to the appliance d Recommended position for electrical socket. Important: Do not position behind the appliance! e Mains connection cable f Ventilation cut-out for installation with a pyrolytic oven...
Installing the appliance ^ Push the appliance into the recess and align it. ^ Secure the appliance by screwing the two wood screws 3.5 x 25 mm i (supplied) into the vertical trim on either side of the appliance (see illustration).
Electrical connection All electrical work should be carried out by a suitably qualified and competent person, in strict accordance with current local and national safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer cannot be held liable for unauthorised work.
Page 58
Electrical connection Important U.K. The wires in the mains lead are coloured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live WARNING: THIS APPLIANCE MUST BE EARTHED Non-rewireable plugs BS 1363 The fuse cover must be refitted when changing the fuse, and if the fuse cover is lost, the plug must not be used until a suitable replacement is obtained.
Please note that telephone calls may be monitored and recorded to improve our service. When contacting Miele, please quote the model and serial number of your appliance, which are given on the data plate. N.B. A call-out charge will be applied for service visits where the problem could have been resolved as described in these instructions.