Table of Contents
Advertisement
INSTALLATION
VIDEO CONNECTIONS
Use coaxial cables when connecting a camera and a
monitor to this VCR.
Note:
Long cable runs to distant cameras may
cause signal deterioration and/or sync discrep-
ancies.
If these problems occur, use video line
amplifiers and/or cameras having phase-adjustable
line-locked vertical sync.
Video Input
In single camera systems, connect the camera to the
Video IN BNC terminal on the VCR rear panel. Use
of a 2:1 interlace camera is highly recommended;
otherwise, the monitor will show vertical distortion
of the TIME/DATE characters.
In multiple camera systems, connect the switcher
output to the Video IN BNC terminal. Because mul-
tiple camera systems require synchronization, use
of cameras having line-locked vertical sync or a gen-
locked master drive/sync source is highly re-
commended. The use of vertical interval switchers
is also recommended.
Video Output
Connect the monitor to the Video OUT BNC terminal
on the rear panel.
MICROPHONE
VIDEO CAMERA/RECORDER
CAMERA
SWITCHER
7
AUDIO CONNECTIONS
Note: Audio recording can be performed at the 03,
12 and 24-hour recording speeds and audio play-
back at the 03, A12, and A24 speeds.
Audio In: Accepts an audio signal from a camera,
external sound equipment, or another recorder
(Line: –8 dBm, 50 kohm).
Audio Out: Provides an audio output for a monitor
or another recorder (–9 dBm, 600 ohm, unbalanced).
PREAMP
MONITOR
Advertisement
Table of Contents
