Table of Contents
Advertisement
XCK-L555 Angle Case Kit
The XCK-L555 allows you to bend the XC-505/505P 90
degrees horizontally (HL).
Note
You can install XC-505/505P in only HL (horizontal)
directions. VL (vertical) is not available with this model.
Dimensions
505HL
22
22
28
Angle type
On the upper position of the Front block z is located. Set
the direction correctly while looking at the Front block
from the front so that z is in the upper position.
Dip switch: rear
74.3
8
85.3
UNIT: mm
Installation
Use angle case A/B and screws.
1
Remove the four screws (+PM1.7 × 3) from the front
panel.
The front block will pop out due to pressure from the
flexible cable.
Front
block
Flexible cable
2
Attach the angle case (B) to the underside of the front
block.
Angle case (B)
Note
Do not pull the front block out forcibly. If you do so,
you may damage the flexible cable.
3
Attach the angle case (A) to the front block.
Angle case (A)
Camera case
5
Connection Diagram
Advertisement
Table of Contents
