Disassembly procedure Chapter Disassembly Procedure Please follow the information provided in this section to perform the complete disassembly procedure of the notebook. Be sure to use proper tools described before. 37E Notebook consists of various modules. This chapter describes the procedures for the complete notebook disassembly.
Disassembly procedure Battery Module B A T T E R Y The illustration below shows how to remove the battery module. Remove Battery module 1.Slide the battery latch 1 to open battery lock 2.Slide the battery latch 2 and pull the whole battery out. CPU Module C P U M O D U L E...
Page 3
Disassembly procedure 2. Remove 2 screws and then disconnect the CPU fan cable. 3. Remove 1 piece of tape here and take away the CPU fan from the system. 4. Remove 7 screws on heat sink and take away the heat sink module. 2 - 3...
Disassembly procedure 5. Turn the non-removable screw here 180 degrees counter-clockwise to loosen the CPU. 6. Squeeze the vacuum handling pump on the CPU and use it to lift the CPU away. M E M O R Y Memory Module M O D U L E The illustration shows how to remove the memory module form the notebook.
Disassembly procedure WLAN Module W L A N The illustration below shows how to remove the WLAN module from the notebook. M O D U L E Remove WLAN module W L A N 1. Disconnect the three antennas here and then remove two screws to pop it up at 45 degree angles and then pull it out at that angle.
Page 6
Disassembly procedure 2. Pull the hard disk module toward the direction of the arrow and then lift it up and take it out. 3. Remove 4 screws to separate HDD from HDD housing. 2 - 6...
Disassembly procedure Optical Drive Module O P T I C A L 1. Push the ODD module softly and slowly pull the ODD module out. D R I V E R E M O V A L 2. Remove 4 screws here and remove the ODD bracket. Bottom Case Module B O T T O M C A S E The illustrations below show how to disassemble and remove the bottom case module of the notebook.
Page 8
Disassembly procedure 2. Put the WLAN antennas through the hole of bottom case. 3. Disconnect the two cables here. 4. Remove 10 screws here on bottom case. 2 - 8...
Page 9
Disassembly procedure 5. Remove the left side cover, right side cover and the bottom case orderly. 2 - 9...
Disassembly procedure Keyboard Module K E Y B O A R The illustrations below show how to remove the keyboard. Removing Keyboard 1. Open 4 latches (Esc, F5, F10 and Pause) on keyboard module. 2. Turn over the keyboard plate and disconnect the keyboard FPC, and then remove the keyboard plate.
Page 11
Disassembly procedure Removing Keyboard Cable 1. Use a flexible connector tool to unlock the cable connector on both ends (no. 1). 2. Carefully pull out the keyboard cable (no. 2) with a pair of tweezers. 3. Lock the connector (no. 3) again to avoid possible breakage. 2.
Page 12
Disassembly procedure 3. Remove both hinge covers and remove 2 screws on each hinge. 4. Put the cables and antennas through the hinge holes. 2 - 12...
Page 13
Disassembly procedure 5. Take the LCD module away. 6. Tear 1 piece of tape here, and then disconnect the fingerprint FPC and speaker cable from mother board. Touchpad cable Fingerprint FPC 7. Remove 7 screws here on mother board and then remove the mother board. 2 - 13...
Page 14
Disassembly procedure 8. Remove the TPM board. 9. Remove 6 pieces of tape here and then disconnect the modem cable from mother board. 10. Remove 2 screws here and remove the modem module. 2 - 14...
Page 15
Disassembly procedure Top Case Module T O P C A S E The illustrations below show how to disassemble and remove the top case module of the notebook. R E M O V A L The module contains the top case itself. Removing Top Case Module 1.
Page 16
Disassembly procedure 4. Remove this black Mylar here and disconnect the fingerprint FPC and touchpad FPC here. 5. Remove 4 screws on fingerprint bracket and take it away. 6. Remove 2 screws here to separate the fingerprint bracket from the fingerprint board. 2 - 16...
Disassembly procedure LCD Module L C D M O D U L E The illustrations below show how to remove and disassemble the LCD module. The module contains LCD panel, Inverter board, LCD bezel, LCD back cover. Disassembling LCD Module L C D M O D U L E 1.
Page 18
Disassembly procedure 4. Disconnect the LCD cable and inverter cable from inverter board, and then take it away. 5. Remove 4 screws here. 2 - 18...
Page 19
Disassembly procedure 6. Take the LCD panel away. 7. Remove 3screws on each LCD bracket and take both brackets away. 8. Remove the white transparent Mylar here and disconnect Coaxial cable from LCD panel, and then remove the coaxial cable. 2 - 19...
Page 20
Disassembly procedure 9. Remove 2 screws on each hinge and take both hinges away. 10. Remove 1 screw here and tear 6 pieces of tape. 11. Take out the camera module and microphone module, and then remove them together. 2 - 20...
Page 21
Disassembly procedure 12. Tear the tape and remove the black antenna. 13. Tear 9 pieces of tape and remove the white antenna and gray antenna. 2 - 21...