Configuring The Cisco Ubr10012 Router Manually Using Configuration Mode - Cisco uBR10012 Software Configuration Manual
Universal broadband router
Hide thumbs
Also See for uBR10012:
- Hardware installation manual (280 pages) ,
- Troubleshooting manual (86 pages) ,
- Quick start manual (72 pages)
Table of Contents
Advertisement
Chapter 2
Configuring the Cable Modem Termination System for the First Time
Configuring the Cisco uBR10012 Router Manually Using
Configuration Mode
You can configure the Cisco uBR10012 router manually if you prefer not to use the Setup facility or
AutoInstall. Complete the following steps:
Connect a console terminal to the console port on the I/O controller.
Step 1
When asked if you want to enter the initial dialog, answer no to go into the normal operating mode of
Step 2
the router:
Would you like to enter the initial dialog? [yes]: no
After a few seconds, the user EXEC prompt
Step 3
(configuration changes can be made only in enable mode):
Router> enable
The prompt changes to the enable mode (also called privileged EXEC) prompt:
Router#
Enter the configure terminal command at the enable prompt to enter configuration mode from the
Step 4
terminal:
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Tip
To see a list of the configuration commands available to you, enter ? at the prompt or type help while
in configuration mode.
At the
Step 5
configuration mode:
Router(config)# interface cable slot/port
Router(config-if)#
Set the downstream center frequency to reflect the digital carrier frequency of the downstream RF carrier
Step 6
(the channel) for the downstream port:
Router(config-int)# cable downstream frequency down-freq-hz
Note
Activate the downstream port on the cable interface line card to support digital data transmission over
Step 7
the hybrid fiber-coaxial network:
Router(config-int)# no shutdown
Enter the fixed center frequency in Hz for your downstream RF carrier and the port number:
Step 8
Router(config-int)# cable upstream port frequency up-freq-hz
Note
OL-1520-05
prompt, enter the interface type slot/port command to enter the interface
Router(config)#
This command has no effect on the external upconverter. It is informational only.
Be sure not to select an upstream frequency that interferes with that used for any other
upstream application in your cable plant.
Cisco uBR10012 Universal Broadband Router Software Configuration Guide
Configuring the Cisco uBR10012 Router Manually Using Configuration Mode
appears. Type enable to enter enable mode
(Router>)
2-13
Advertisement
Chapters
Table of Contents
Troubleshooting
