TO BE REMOVED BY THE CUSTOMER
AFTER INSTALLATION
iS COMPLETE.
f
[]
[]
[]
iNSTALLATiON
CHECKOFF
LiST
Doors
[]
Handles are secure and tight
[]
Door seals completely to cabinet on all sides
[]
Doors are level across the top
Leveling
[]
Refrigerator is level, side to side and tilted 1/4" (6mm) front to back
[]
Toe grille is properly attached to refrigerator
[]
Cabinet is setting solid on all corners
Electrical
Power
House power turned on
Refrigerator plugged in
ice Maker
[]
House water supply connected to refrigerator
[]
Water & power couplings connected at door
[]
No water leaks present at all connections - recheck in 24 hours
[]
Ice Maker is turned ON.
[]
Ice & Water Dispenser operates correctly
[]
Front filter must be flush with filter housing (some models)
Final Checks
[]
Shipping material removed
[]
Fresh Food and Freezer controls set
[]
Crisper Humidity controls set
[]
Registration Card sent in
.o o.°o,!,
c.,o M.°u,i
I
additional
information
about your refrigerator!
Tools You Will Need:
1
HAND TRUCKING
, Load refrigerator from side of cabinet
only.
• Do not run retaining straps over
handles.
Do not over-tighten retaining straps.
Never use refrigerator handles to
move the refrigerator.
• Remove tape from doors only after
unit is in place.
.J
INSTALLATION
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation,
and plumbing
and electrical
connections:
•
Sides &Top .......... 3/8"
Back ....................... 1"
NOTE: If you are installing your refrigerator beside a wall,
leave 1/2" minimum between hinges and wall to allow for
the door to swing open.
J
Ensureicemakeris turned ON. Togain access to the ice maker,
slide the ice cream tray out. Check to see that the Ice & Water
Dispenser is operating correctly. (See Automatic Ice & Water
Dispenser Features in Use & Care Manual.)
J
SHIPPING
MATERIAL
1 PIECE OF FOAM
OR CARDBOARD
2 WIRE TIES
[_tc:_-
(All wire basket
_
'_
will have 2 wire
ties)
......... 1 PIECE OF TAPE
............
1 PIECE OF TAPE
OR
.... 2 BLUE SHIPPING
CLIPS
1 PIECE OF TAPE
...........
SHELF SPACER
WITH
TOE GRILLE
1 PIECE OF TAPE
.... 3 PIECES OF TAPE
......... 1 PIECE OF TAPE
Remove Shipping
material.
'Features may vary per model.)
f
LEVELING
AND ADJUSTING
All four corners of refrigerator must rest firmly on a solid
floor.Your refrigerator has adjustable rollers to help level it
F
3
WATER SUPPLY
....
Connect water supply - check for water leaks. Turn icemaker OFF
if water supply is not connected
immediately. Connecting
to a
reverse osmosis system is not recommended.
J
F
A
F,,_
R,r,_r4_r
/\
and to adjust the doors.
To level cabinet or change door height:
1. Remove toe grille.
2. Use a screwdriver, 3/8" wrench, or nutdriver to adjust the
rollers.To raise cabinet or door, turn screw clockwise. To
lowercabinet or door, turn screw counterclockwise.
Cabine_
: od
L,
ii
o ve. I
__Door ]L
OOOR _j
Door
-.
Water
•
-."
Line
Hinge
Assembly
Screws
If you need to remove the doors to get your refrigerator in the house, please See
Door Removal Instructions in your Use & Care Manual.
When changing
control settings,
wait 24 hours before making additional adjustments.
9
%
_/
See"Normal
Operating Sights & Sounds" in the Use & Care
Manualso you understand the sounds you may hear once
your refrigerator is running.
_/
Please read entire Use & Care Manualto
become aware of
important safety instructionsand to become familiar with your
new refrigerator.
_/
Send in Registration
card to register your refrigerator.
",J Congratulations!
You are ready to enjoy your new refrigerator.
J
IFYOU ARE DISSATISFIED
WITH THE INSTALLATION
OFYOUR
REFRIGERATOR,
PLEASE CALLTHE
STORE YOU PURCHASED
IT FROM.
P/N: 2 41570202