Table of Contents
Advertisement
Administration
File Management
STEP 3
STEP 4
STEP 5
STEP 6
Cisco Small Business SG200 Series 8-port Smart Switch
Stop the control at boot code by pressing and holding <Ctrl> + C continuously as
the switch boots up, until the following prompt displays:
CFE>
Enter the command to download a software image:
CFE>flash uart0 flash0.os
Or, enter the command to download a boot code file:
CFE>flash uart0 flash0.boot
WARNING!
Make sure that the switch is connected to an uninterrupted power
supply during a boot code upgrade. This process might take 10–20 seconds.
The switch waits for a file to be sent from the management station.
In the terminal emulation software, select the file and begin the transfer.
For example, in Tera Term, click File > Transfer > XMODEM > Send, and then
browse to select the file.
When the download is complete, the switch burns the image or boot code file into
Flash memory.
Enter the command to restart the switch to boot it with new software:
CFE>reset -sysreset
NOTE:
You can verify the boot code or image version by viewing the System
Summary page in the web-based switch configuration utility. Or, from the
command line interface, you can enter the show sysinfo command.
3
73
Hide quick links:
Advertisement
Table of Contents
