Using The Clear Cmos Header J2065 - Cisco UCS C24 Installation And Service Manual
Hide thumbs
Also See for UCS C24:
- Installation and service manual (128 pages) ,
- Installation and service manual (100 pages)
Table of Contents
Advertisement
Service Headers and Jumpers
Using the Clear CMOS Header J2065
See
settings in the case of a system hang. For example, if the server hangs because of incorrect settings and
does not boot, use this jumper to invalidate the settings and reboot with defaults.
Clearing the CMOS removes any customized settings and might result in data loss. Make a note of any
Caution
necessary customized settings in the BIOS before you use this clear CMOS procedure.
Power off the server as described in
Step 1
Disconnect all power cords from the power supplies.
Step 2
Slide the server out the front of the rack far enough so that you can remove the top cover. You might have
Step 3
to detach cables from the rear panel to provide clearance.
Caution
Remove the top cover as described in
Step 4
Move the shorting jumper to pins 2 and 3 of the J2065 header (see
Step 5
Reinstall the top cover and reconnect AC power cords to the server. The server powers up to standby
Step 6
power mode, indicated when the Power LED on the front panel is amber.
Return the server to main power mode by pressing the Power button on the front panel. The server is in
Step 7
main power mode when the Power LED is green.
Note
Press the Power button to shut down the server to standby power mode, and then remove AC power cords
Step 8
from the server to remove all power.
Remove the top cover from the server.
Step 9
Move the shorting jumper from header pins 2 and 3, back to its default position on pins 1 and 2.
Step 10
Note
Replace the top cover, replace the server in the rack, replace power cords and any other cables, then
Step 11
power on the server by pressing the Power button.
Cisco UCS C240 Server Installation and Service Guide
2-20
Figure 2-6
for the location of this header. You can jumper this header to clear the server's CMOS
If you cannot safely view and access the component, remove the server from the rack.
You must allow the entire server, not just the service processor, to reboot to main power mode
to complete the reset. This is because the state of the jumper cannot be determined without the
host CPU running.
If you do not move the jumper, the CMOS settings are reset to the default every time that you
power-cycle the server.
Shutting Down and Powering Off the Server, page
Removing and Replacing the Server Top Cover, page
Chapter 2
Installing the Server
3-7.
3-8.
Figure
2-6).
OL-25761-01
Advertisement
Table of Contents
