Cisco UCS C24 Installation And Service Manual page 68

Hide thumbs Also See for UCS C24:

Table of Contents

Installing or Replacing Server Components

Slide the server out the front of the rack far enough so that you can remove the top cover. You might

have to detach cables from the rear panel to provide clearance.

Caution

If you cannot safely view and access the component, remove the server from the rack.

Remove the top cover as described in

page

Identify the faulty DIMM by observing the DIMM slot fault LEDs on the motherboard (see

Figure

Open the ejector levers at both ends of the DIMM slot, then lift the DIMM out of the slot.

Install a new DIMM:

Step 2

Note

Align the new DIMM with the empty slot on the motherboard. Use the alignment key in the DIMM

slot to correctly orient the DIMM.

Push down evenly on the top corners of the DIMM until it is fully seated and the ejector levers on

both ends lock into place.

Replace the top cover.

Replace the server in the rack, replace cables, and then power on the server by pressing the Power

button.

Cisco UCS C240 Server Installation and Service Guide

3-28

3-8.

3-3).

Before installing DIMMs, refer to the population guidelines. See

Guidelines and Population Rules, page

"Removing and Replacing the Server Top Cover" section on

3-24.

Chapter 3

Maintaining the Server

Memory Performance

OL-25761-01

Table of Contents

Ucs c240