Table of Contents
Advertisement
Mounting Instructions
Mounting Instructions
This section includes all the steps required to mount the router on a wall or DIN rail. There are two main
procedures for mounting the router:
1.
2.
In some environments, you might want to mount the router on a wall instead of DIN rail. The wall
mounting procedure is described in
Attach the Mounting Bracket to the Router
Before you begin, disconnect the router from power and any network connections.
Place the router on a stable surface, with the base of the router facing up and the module panel at the top,
Step 1
as shown in
Use the #2 Phillips screwdriver to remove the four large screws (Item 1,
Step 2
base. Keep the screws. You will replace them at the end of this procedure to mount the bracket on the
chassis.
Remove only the screws indicated in
Step 3
router bottom panel to the chassis.
Figure 4-2
1
Cisco 1120 Connected Grid Router Hardware Installation Guide
4-4
Attach the Mounting Bracket to the Router, page 4-4
Mount the Router on a DIN Rail, page 4-6
Figure
4-2.
Remove the Four Large Screws (1) from the Router Base
Mount the Router on a Wall, page
Figure
4-2. Do not remove the smaller screws, which secure the
Module Panel
Cable Panel
Chapter 4
Mounting the Router
4-7.
Figure
4-2) from the chassis
1
OL-26438-02
Hide quick links:
Advertisement
Table of Contents
