Verify Te Tunnel And Tunnel Path - Cisco ASR 903 Manual
Hide thumbs
Also See for ASR 903:
- Release notes (280 pages) ,
- Installation manual (200 pages) ,
- Hardware installation manual (196 pages)
Table of Contents
Advertisement
MPLS TE Configuration
Creating Tunnel12 using Red Path
ASR903-R1 Configuration
interface Tunnel12
ip unnumbered Loopback10
tunnel source Loopback10
tunnel mode mpls traffic-eng
tunnel destination 10.10.4.4
tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng priority 3 3
tunnel mpls traffic-eng bandwidth 500
tunnel mpls traffic-eng affinity 0x1 mask 0x1
tunnel mpls traffic-eng path-option 3 dynamic
interface GigabitEthernet0/1/1
mpls traffic-eng attribute-flags 0x1
ASR903-R3 Configuration
interface GigabitEthernet0/1/1
mpls traffic-eng attribute-flags 0x1
!
interface GigabitEthernet0/1/1
mpls traffic-eng attribute-flags 0x1
ASR903-R4 Configuration
interface GigabitEthernet0/1/1
mpls traffic-eng attribute-flags 0x1
Verify TE tunnel and Tunnel Path
ASR903-R1# show mpls traffic-eng tunnels tunnel 12
Name: ASR903-R1_t12
Status:
Admin: up
path option 3, type dynamic (Basis for Setup, path weight 2)
Config Parameters:
Bandwidth: 500
Metric Type: TE (default)
AutoRoute: enabled
auto-bw: disabled
Active Path Option Parameters:
State: dynamic path option 3 is active
BandwidthOverride: disabled
OL-30526-01
Oper: up
Path: valid
kbps (Global)
Priority: 3
LockDown: disabled Loadshare: 500 [4000000] bw-based
LockDown: disabled
(Tunnel12) Destination: 10.10.4.4
Signalling: connected
3
Affinity: 0x1/0x1
Verbatim: disabled
Cisco ASR 903 Router Design and Deployment Guide▄
Explicit Path by using Affinity ▀
99
Hide quick links:
Advertisement
Table of Contents
