Attention Installer; Electrical Connections - GE JTP86 Installation Instructions Manual
30” built-in wall oven with microwave
Hide thumbs
Also See for JTP86:
- Owner's manual (44 pages) ,
- Installation instructions manual (12 pages) ,
- Technical service manual (51 pages)
Table of Contents
Advertisement
Installation Instructions
Electrical Connections
B
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
DO NOT shorten the flexible conduit.
The conduit strain relief clamp must be
securely attached to the junction box
and the flexible conduit must be securely
attached to the clamp. If the flexible
conduit will not fit within the clamp, do not
install the oven until a clamp of the proper
size is obtained.
NOTE TO ELECTRICIAN: The 3 power
leads supplied with this appliance are
UL recognized for connection to heavier
gauge household wiring. The insulation
of these 3 leads is rated at temperatures
much higher than the temperature rating
of household wiring. The current carrying
capacity of the conductor is governed
by the wire gauge and the temperature
rating of the insulation around the wire.
WARNING:
connection of aluminum house
wiring to copper leads can
result in an electrical hazard or fire.
Use only connectors designed for
joining copper to aluminum and follow
the manufacturer's recommended
procedure closely.
Improper
Turn off the circuit breaker or remove
B1
fuses to the oven branch circuit.
With the oven supported on a table or
B2
platform in front of the cabinet opening,
connect the flexible conduit to the
electrical junction box as shown below.
Position the conduit in such a manner
that it will lie on top of the oven in
a natural loop when the oven is
installed. You will need to purchase
an appropriate strain relief clamp to
complete the connection of the conduit
to the junction box.
Conduit
48 1/2" long
Place oven on a
support to assist in
connecting conduit
6
20"
Junction Box
Location
GROUND
WIRE
BARE
GROUND
RED
WHITE
BLACK
Strain Relief Clamp
(not included)
must be used at
Junction Box
(Continued on following page)
- Quick Links:
- Electrical Connections
Hide quick links:
Advertisement
Table of Contents
