Safety instructions Your new fridge may have other functions compared to your previous one. Carefully read these instructions to learn how the appliance works and how to care for it. Keep the instruction booklet. It will come in handy if you later sell the cabinet or give it to somebody else. These warnings are provided in the interests of your safety.
Before use Position and clean the cabinet as explained in the section "Installation". Check that the drain hose at the rear of the cabinet discharges into the drip tray. Before inserting the power plug into the outlet and switching on the cabinet for the first time, leave it standing upright for about 4 hours.
Hints: · Distribute foodstuffs to allow cold air to circulate freely between the products. · Do not place food products directly against the cooling plate on the rear wall since they may freeze in this case. · Also never put warm products into the cabinet. Wait until they have cooled down.
Remove suspect food from you refrigerator and · Always leave warm food to cool down to room clean, refer to cleaning and maintenance. temperature before placing in the fridge. · Make sure the door gasket is complete and Protect the environment always clean.
Defrosting the fridge The fridge is defrosted automatically every time the compressor stops. Frost formation can be prevented · not putting warm foodstuff inside the cabinet. · avoiding frequently opening the door or keeping it open too long. · do not place foodstuffs directly against the cold cooling plate.
The compressor operates continuously. Set a warmer temperature. Make sure that the door is completely closed and that the insulating strip is complete and clean. The temperature where the cabinet is placed is above normal room temperature. The cabinet does not operate at all. The cabinet is not switched on.
Technical specification ERC3700 ERC3200 Model 361 l 314 l Volume fridge Width 595 mm 595 mm 1800 mm 1600 mm Height 600 mm 600 mm Depth Energy consumption 248 kWh/year 230 kWh/year Energy class 110W 110W Rated power Installation Unpacking Unpack the cabinet and check that it is in good condition and free of any transport damage.
Installing the cabinet To obtain the best performance from the cabinet, ensure : · the cabinet is placed in a dry, cool place and is not exposed to direct sunlight. · the cabinet is not placed close to a source of heat, e.g.
Door Reversal 1. Close the cabinet and remove the plug from the electrical socket. 2. Remove the ventilation grille. There is a part on the grille that can be removed. Reposition it and put it on the other side. 3. Put the cabinet on a wooden board when it is laid down.