Safety System; Switching Off A Burner; Power Levels; Warnings - Siemens Hob Instruction Manual
Hide thumbs
Also See for Hob:
- Operating instructions manual (74 pages) ,
- Use & care and installation manual (48 pages) ,
- Instruction manual (33 pages)
Table of Contents
Advertisement
If it does not come on, turn the control
knob to the off setting and repeat the steps
above. This time, press and hold the
control knob for longer (up to 10 seconds).
m
Risk of deflagration!
If after 15 seconds the flame does not
ignite, switch off the burner and open a
nearby window or door. Wait at least one
minute before trying to switch the burner
back on.
Safety system
Depending on the model, your hob may
have a safety system (thermocouple) that
prevents the flow of gas if the burners
accidentally switch off.
,JQLWLRQ
7KHUPRFRXSOH
VSDUNHU
To ensure that this device is active:
Switch on the burner as usual.
1.
Without releasing the control knob, press
2.
and hold it down firmly for 4 seconds
after lighting the flame.
Switching off a burner
Turn the corresponding control knob
clockwise to the 0 setting.
Power levels
The progressive control knobs can be used
to control the power needed, from
minimum to maximum power.
Setting
Û
High flame
ƒ
Low flame
„
8
Control knob off
Maximum capacity or aperture
and electricity on
Minimum capacity or aperture
Warnings
It is normal to hear a soft whistling noise
while the burner is operating.
When it is first used, it is normal for the
burner to give off odours. This does not
pose any risk and does not indicate a
malfunction. They will disappear in time.
An orange-coloured flame is normal. This is
caused by the presence of dust in the
atmosphere, spilt liquids, etc.
The kitchen will become hot and humid
when this gas appliance is used. You must
therefore ensure that the kitchen is well
ventilated: Either keep the natural
ventilation apertures open, or install a
ventilation system (extractor hood).
Intense and prolonged use of the appliance
may mean additional ventilation is required
(for example, opening a window) or more
effective ventilation (for example,
increasing the hob's ventilation, if possible).
If the burner flames are accidentally blown
out, switch off the burner operating control
knob and do not try to relight it for at least
one minute.
A few seconds after the burner is switched
off, a sound (thud) will be produced. This is
not a fault - this means that the safety
device is no longer operating.
Keep the burner as clean as possible. If the
ignition sparkers are dirty they will not light
properly. Clean them periodically using a
small non-wire brush. Bear in mind that the
ignition sparkers must not suffer any
serious impacts.
Due to the plastic covering used to protect
the stainless steel on this appliance, you
may find remains of adhesive on engraved
areas. Remove them using a damp cloth.
- Quick Links:
- Switching on Manually
- Trouble Shooting
Hide quick links:
Advertisement
Table of Contents
