Table of Contents
Advertisement
Software/Firmware
Revision Level
Alarm Status
Internal
Temperature
TX Timeout-Timer
TX Frequency
MDS 05-3305A01, Rev. E
Using the SNR command causes the
and the SNR is updated and redisplayed every 2 sec. The SNR continu-
ously updates until you press the
SREV
This command displays the software revision level of the transceiver
firmware.
STAT
This command displays the current alarm status of the transceiver.
If no alarms exist, the message
of the HHT display.
If an alarm does exist, a two-digit code (00–31) is displayed and the
alarm is identified as "Major" or "Minor." A brief description of the
alarm code is also provided.
If more than one alarm exists, the word
the screen and additional alarms are viewed by pressing the
key. Detailed descriptions of event codes are provided in
Page
34.
TEMP
This command displays the internal temperature of the transceiver in
degrees Celsius.
TOT [1-255, ON, OFF]
This command sets or displays the transmitter Time-out Timer value
(1–255 sec), as well as the timer status (
and the radio remains keyed for a longer duration than the
transmitter is automatically unkeyed.
When this happens, you must command the radio back to an unkeyed
state before a new keying command is accepted. The default timer value
is 30 sec.
TX [xxx.xxxx]
This command selects or displays the radio's transmit frequency in
MHz. The frequency step size is 6.25 kHz.
If the customer frequency is not programmed at the factory, a default
frequency is programmed in the radio near the center of the frequency
band.
MDS 4710/9710 Technical Manual
DIAG
port to enter an update mode,
key.
ENTER
appears at the top
NO ALARMS PRESENT
appears at the bottom of
MORE
or
). If the timer is on,
ON
OFF
ENTER
Table 11 on
value, the
TOT
31
Hide quick links:
Advertisement
Table of Contents
