SAFETY PRECAUTIONS IMPORTANT SAFETY NOTICE Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and Replacement Parts List. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent Shock, Fire, or other Hazards.
SERVICING PRECAUTIONS CAUTION: Before servicing receivers covered by this service unit under test. manual and its supplements and addenda, read and follow the 2. After removing an electrical assembly equipped with ES SAFETY PRECAUTIONS on page 3 of this publication. devices, place the assembly on a conductive surface such as NOTE: If unforeseen circumstances create conflict between the aluminum foil, to prevent electrostatic charge buildup or...
Page 5
IC Remove/Replacement Some chassis circuit boards have slotted holes (oblong) through Circuit Board Foil Repair which the IC leads are inserted and then bent flat against the Excessive heat applied to the copper foil of any printed circuit circuit foil. When holes are the slotted type, the following technique board will weaken the adhesive that bonds the foil to the circuit should be used to remove and replace the IC.
34.40MHz(Sound) 2) DVB-T : 36.125MHz Input Voltage AC 240 V, 50Hz Maker : LGE LCD Module 37" : LC370WX3-SLA1 WXGA Maker : LG Philips LCD 42" : LC420WX6-SLA1 WXGA Aspect ratio 16:9 (wide) Operating Temperature Operating Humidity Storage Temperature Storage Humidity...
Page 7
5. Chroma & Brightnes Item Unit Remark White peak Brightness cd/m HDMI input, full white, Video Black level=Hight Contrast Ratio 600 : 1 800 : 1 Brightness uniformity Refer to LCD spec. Color coordinate 0.633 ± 0.03 0.339 ± 0.03 GREEN 0.286 ±...
ADJUSTMENT INSTRUCTION 1. Application Object These instructions are applied to all of the 37"/42" LCD TV, LB73A Chassis 2. Notes (1) Because this is not a hot chassis, it is not necessary to use an isolation transformer. However, the use of isolation transformer will help protect test equipment.
Page 10
5. Video(uPD)-Set adjustment 6. EDID (The Extended Display Identification Data) /DDC Download (Display Data Channel) 5-1. Synopsis This is a adjustment to reduce the color difference of video This is the function that enables “Plug and Play". signal Main/Sub Display. 5-2.
6-2. Setting of Device 6-3-2. 42LC7D-AB (1) EDID DATA PORT1 for HDMI 6-3. EDID DATA 6-3-1. 37LC7D-AB 0 00 FF FF FF FF FF FF 00 1E 6D 01 00 01 01 01 01 (1) EDID DATA PORT1 for HDMI...
Page 12
7. Adjustment of White Balance 7-4. Adjustment of White Balance (Passivity Adjustment) 7-1. Required Equipment Operate Zero Calibration of the CA-210. Manual adjustment is also possible by the following sequence. (1) Color analyzer (CA-210 or similar product) (2) Automatic adjustor (with automatic adjustment hour (1) Enter to ‘7.
EXPLODED VIEW IMPORTANT SAFETY NOTICE Many electrical and mechanical parts in this chassis have special safety-related characteristics. These parts are identified by in the Schematic Diagram and EXPLODED VIEW. It is essential that these special safety parts should be replaced with the same components as recommended in this manual to prevent X-RADIATION, Shock, Fire, or other Hazards.