Replacing Bushings - Husqvarna Rider ProFlex 18 Workshop Manual

Hide thumbs Also See for Rider ProFlex 18:

Operator's manual (88 pages)

Workshop manual (68 pages)

Operator's manual (96 pages)

Table Of Contents

Table of Contents

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

Remove the fan; it is held in place by a nut

and washer.

Loosen the idler's spring (1) and pull off the

drive belt.

Remove the locking spring and loosen the

throttle control's link joint (2) (on the

underside), and remove the cable from the

underside of the shaft.

Loosen the cable from the neutral position

contact (5).

Loosen the brake cable's (3) spring and

nuts and pull off the cable from the brake

arm.

10. Loosen the cable to the differential lock on

ProFlex 21, see "Removing/Mounting the

Hydrostatic Transmission" on page 44.

11. Remove the circlip and washer from the

pendulum shaft (4) and pull loose the rear

frame.

12. Remove the circlip and washer from the

pendulum shaft's inner mount (1) and pull

the shaft out to the rear. Use a

sledgehammer or puller if needed.

If the dust cover (2) is damaged, it should

be replaced with a new one.