ORDER No. SM-99042 Colour Television TX-28MK1P/M TX-21MK1P/M EURO-4 Chassis SPECIFICATIONS (Information in brackets {} refers to model TX-21MK1P/M) AV2 IN Video (21 pin) 1V p-p 75Ω Power Source: 220-240V a.c., 50Hz Audio (21 pin) 500mV rms 10kΩ S-Video IN Y: 1V p-p 75Ω...
Set the brightness to minimum. LEAKAGE CURRENT HOT CHECK Measure the high voltage. The meter should indicate. Plug the a.c. cord directly into the a.c. outlet. Do not TX-28MK1P/M 28,2kV± 1kV. use an isolation transformer for this check. TX-21MK1P/M 28kV ± 1kV.
SERVICE HINTS How to remove the rear cover 1. Remove the 9 screws as shown in Fig.2. SCREWS Fig.2. LOCATION OF CONTROLS FOCUS SCREEN E-BOARD H-BOARD Y-BOARD Fig.3.
ADJUSTMENT PROCEDURE Item / Preparation Adjustments +B SET-UP 1. Set the +B voltage up as follows:- Adjust R811 so that B2 shows 148V±1V [130V±1V Receive a Greyscale signal. TX-21MK1P/M] Set the controls :- 2. Confirm the following voltages. ± 0,25V ±...
WAVEFORM PATTERN TABLE Vert Drive VFLB Vert Out IC451 Pin 2 IC451 Pin 3 IC601 Pin 31 20mS 20mS 20mS H - Out H - Out H - Pulse IC601 Pin 50 IC701 Pin 5 Base Q503 64µS 64µS 64µS HFLB HFLB Video Out...
ALIGNMENT SETTINGS (The figures below are nominal and used for representative purposes only.) Alignment Function Settings / Special features H-Pos Horizontal Position Optimum setting. V-Pos Vertical Position Optimum setting. H-Amp Horizontal Amplitude Optimum setting. V-Amp Vert. Amplitude Optimum setting. E/W-Amp1 EW-amplitude Optimum setting.
VIDEO BLOCK DIAGRAM E - BOARD Y - BOARD TX-28MK1P/M ONLY Q906 Q908 COILS TX-28MK1P/M ONLY Q905 Q907 Q909 IC601 61 V IN 1 Q950 Q951 Q104 IC351 SVM OUT 34 VIDEO PROCESSOR B OUT 39 Q353 43 B IN...
REPLACEMENT PARTS LIST Important Safety Notice Components Identified by mark have special characteristics important for safety. * When replacing any of these components, use only manufacturers specified parts. In case of ordering these spare parts, please always add the complete Model-Type number to your order.
SCHEMATIC DIAGRAMS FOR MODELS TX-28MK1P/M / TX-21MK1P/M (EURO-4 CHASSIS) IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise.