Power Off The Cisco Asr 1002 Router - Cisco ASR 1002 Quick Start Manual
Asr 1002 router
Hide thumbs
Also See for ASR 1002:
- Hardware installation manual (57 pages) ,
- Software configuration manual (378 pages) ,
- Replacing (120 pages)
Table of Contents
Advertisement
Power Off the Cisco ASR 1002 Router
This section explains how to shut down the Cisco ASR 1002 Router. It is recommended that before turning off all power to the
chassis, you issue the reload command. This insures that the operating system cleans up all the file systems. Once the reload
operation is complete, then the Cisco ASR 1000 Series router can be powered off safely.
To remove power from the Cisco ASR 1002 Router, follow this procedure:
Slip on the ESD-preventative wrist strap that was included in the accessory kit.
Step 1
Before you shutdown the router, issue the IOS reload command to halt the system and then wait for ROM Monitor to
Step 2
execute before proceeding to the next step. The following screen shot shows an example of the reload command:
Router#reload
Proceed with reload? [confirm]
*Jun 18 19:38:21.870: %SYS-5-RELOAD: Reload requested by console. Reload Reason: Reload command.
Remove any power cables from the Cisco ASR 1002 Router.
Step 3
a. For AC power supplies, switch the circuit breaker to the off (O) position and unplug the AC power cord from the
power outlet.
b. For DC power supplies, place the power switch in the Standby position. Then remove the terminal block plug from the
DC power supply.
After powering off the router, wait a minimum of 30 seconds before powering it on again.
Note
Replace the Cisco ASR1000-ESP5 or ASR1000-ESP10
This section provides instructions for removing the Cisco ASR1000-ESP5 or ASR1000-ESP10 from the Cisco ASR 1002 Router.
The Cisco ESP5 and ESP10 are Cisco Quantum Flow Processors (QFP) for the Cisco ASR 1002 Router. The Cisco ESP5 and
ESP10 are individual FRUs and support online insertion and removal operation. Before you begin, make certain the chassis is
grounded.
To remove the Cisco ESP5 or ESP10 from the Cisco ASR 1002 Router, follow this procedure:
Step 1
Slip on the ESD-preventative wrist strap that was included in the accessory kit. Loosen the captive screws on the Cisco
ESP5 or ESP10.
Using the handles on both sides of the module, with two hands, gently slide the Cisco ESP5 or ESP10 out of the chassis
Step 2
slot.
Note
Handle the Cisco ESP5 and ESP10 by the carrier edges only; never touch the printed circuit board components or
connector pins.
Place the Cisco ESP5 or the ESP10 on an antistatic surface with its printed circuit board components facing upward or
Step 3
in a static shielding bag.
You have completed the procedure for removing the Cisco ESP5 or ESP10.
To install the Cisco ESP5 or ESP10 in the Cisco ASR 1002 Router, follow this procedure:
Slip on the ESD-preventative wrist strap that was included in the accessory kit.
Step 1
29
Advertisement
Table of Contents
