Equipment That You Supply To Run Express Setup; Running Express Setup - Cisco Catalyst 3750G Getting Started Manual

Integrated wireless lan controller switch

Hide thumbs Also See for Catalyst 3750G:

Table of Contents

Equipment that You Supply to Run Express Setup

You need to supply this equipment to run Express Setup:

• PC

• Ethernet (Category 5) straight-through cable (as shown)

When you first set up the switch, you should use Express Setup to enter the initial IP information.

Doing this enables the switch to connect to local routers and the Internet. You can then access the

switch through the IP address for further configuration.

To run Express Setup:

Verify that no devices are connected to the switch. During Express Setup, the switch acts

Step 1

as a DHCP server. If your PC has a static IP address, before you begin, change your PC

settings to temporarily use DHCP.

Connect the AC power cord to the switch and to a grounded AC outlet. The power-on

Step 2

self-test (POST) begins. During POST, the LEDs blink while a series of tests verify that the

switch functions properly.

Wait for the switch to complete POST. It might take several minutes for the switch to

Step 3

complete POST.

Verify that POST has completed by confirming that the SYST LED remains green. If the

Step 4

switch fails POST, the SYST LED turns amber.

POST errors are usually fatal. Call Cisco Systems immediately if your switch fails POST.

Table of Contents

Show Quick Links

Table of Contents