Service Manual Colour Television EURO 2 Chassis TX-25AD1E TX-29AD1E Safety Adjustments Notes Self Check Specifications Service Support Service Hints Block Diagram(Video) Mechanical View Block Diagram(Audio) Disassembly Block Diagram(Control) Location of Controls Parts List About..Waveforms Service Information E Schematic (25)
SM - 95015 Service Manual Colour Television TX-29AD1E TX-25AD1E EURO-2 Chassis Specifications ( Information in brackets {} refer to TX-25AD1E) Power Source : 220-240V AC 50Hz AV2 IN Video (21 pin ) 1 Vp-p 75W Audio (21 pin ) 500mV rms,10 kW...
Contents Safety Precautions Location of Controls Chassis Service Position Service Mode Self Check Adjustment Procedure Alignment Settings Waveform Pattern Table P.C.B. Views Block Diagrams Schematic Diagrams Parts Location Replacement Parts List Safety Precautions General Guide Lines It is advisable to insert an isolation transformer in the AC Use an AC voltmeter with high impedance to measure the supply before servicing a hot chassis.
Location Of Controls Service Hints How to remove the rear cover Remove the 8 fixing screws (A) as shown in Fig.3/Fig.4.
Page 5
How to move the chassis into the Service position Hold and lift the rear of the E- PCB chassis and M - PCB as shown in fig.5. and gently pull the chassis toward you. Realese the M - PCB as explained on page 6 Turn the chassis through 90 , anti-clockwise, as shown in fig.6.
Page 6
HOW TO REMOVE THE CONTROL PANEL (M-BOARD) Remove the E-board from the cabinet with the M-board attached. Unclip by lifting the front of the M-board vertically. After servicing ensure all wiring is returned to its original position before returning the receiver to the customer. HOW TO REMOVE THE A - BOARD Disconnect the 5 leads from the A - board.
Page 7
Service position for the A-Board Remove the A-board from the main chassis (E-board) as shown in Fig.8. Remove the two screws (A) (fig.9) from the plastic AV cover and unclip the AV cover from the A-board. Carefully unclip the three metal clips marked B in fig.9. Unclip the front metal cover (Fig10) and remove from the A-board.
Service Mode The remote control is used for entering and storing adjustments, with the exception of cut-off adjustments which must always be done prior to service adjustment. Perform adjustments in accordance with screen display. The display on the screen also specifies the CCU variants as well as the approx.
SELF CHECK Self check is used to automatically check the Bus lines and Hexadecimal code of the TV set. To enter the Self Check mode press Function down button, on the Preset Panel, at the same time pressing the Status button, on the Remote Control, and the screen will show:- Adjustment Procedure Item/Preparation...
Page 16
SCHEMATIC DIAGRAM FOR MODELS TX-29/25AD1E (EURO-2S CHASSIS) Notes RESISTOR All resistors are carbon ¼W resistor, unless marked. Unit of resistance is OHM (W) (K=1,000, M=1,000,000). CAPACITOR All capacitors are ceramic 50V capacitors, unless marked, the unit of capacitance is mF unless otherwise stated. COIL Unit of inductance is mH, unless otherwise stated.
REPLACEMENT PARTS LIST Important Safety Notice PARTS COMMON TO TX-29AD1E AND TX-25AD1E C229 ECKC1H102J CERAMIC 1000pF MISCELLANEOUS COMPONENTS C462 ECEA1EU101 ELECT 100mF EUR51920 REMOTE CONTROL C463 ECEA1EU471 ELECT 470mF ********** SEE DIFFERENCE LIST C465 ECEA1CU470 ELECT 47mF ********** SEE DIFFERENCE LIST...